Isuzu KB P190. Manual — part 733
Engine Mechanical – V6
Page 6A1–155
Page 6A1–155
24
Verify the proper placement of the primary timing
chain tensioner gasket tab (1).
25
Tighten the primary timing chain tensioner bolts (2) to
the correct torque specification.
Primary timing chain tensioner
attaching bolt torque specification. . ...20.0 – 26.0 Nm
Figure 6A1 – 216
26
Release the primary timing chain tensioner (1) by
pulling out Tool No. EN 46112 (2) and unlocking the
tensioner shaft.
Figure 6A1 – 217
Engine Mechanical – V6
Page 6A1–156
Page 6A1–156
27
Verify the primary and left-hand secondary timing
chain timing mark alignments (1 to 12).
Figure 6A1 – 218
28
Remove Tool No. EN 46105 from the left-hand and right-hand cylinder head camshafts.
Primary Timing Chain Components – MY06 Update
1
If previously removed, install the left-hand secondary
timing chain components, refer to Left-hand
Secondary Timing Chain Components in this Section.
CAUTION
The right-hand camshaft intermediate
sprocket (2) is marked with the letters RB
and ‘FRONT’, and the left-hand sprocket (1)
is marked with the letters LB and 'FRONT'
Ensure the correct sprocket is used and the
FRONT text is facing forwards when
installed.
2
Ensure the right-hand camshaft intermediate
sprocket (2) is selected and orientated correctly.
Figure 6A1 – 219
Engine Mechanical – V6
Page 6A1–157
Page 6A1–157
3
Install the right-hand camshaft intermediate
sprocket (2).
4
Install the sprocket bolt (1) and tighten to the correct
torque specification.
Camshaft intermediate sprocket
attaching bolt torque specification. . ...58.0 – 72.0 Nm
Figure 6A1 – 220
5
Ensure that the crankshaft sprocket timing mark (1) is
aligned with the indexing mark (2) on the oil pump
housing.
Figure 6A1 – 221
6
Install the primary timing chain (1).
Figure 6A1 – 222
Engine Mechanical – V6
Page 6A1–158
Page 6A1–158
7
Wrap the primary timing chain around the large
sprockets of each camshaft intermediate sprocket
and the crankshaft sprocket, aligning the bright plated
chain links as follows:
Figure 6A1 – 223
8
The left-hand camshaft intermediate sprocket timing
mark (1) will align with a bright plated primary timing
chain link (2).
Figure 6A1 – 224
9
The right-hand camshaft intermediate sprocket timing
mark (1) will align with a bright plated primary timing
chain link (2).
Figure 6A1 – 225
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст