Isuzu KB P190. Manual — part 1443

10-14 CAB

13. Window Glass

• Remove 2 bolts through the access hole and pull out the

window glass upward.

14. Window Regulator/Power Window Regulator

• Remove the 4 fixing bolts and the 2 fixing nuts.
• Disconnect the power window motor connector.

15. Glass Run

• Pull it out from the door frame of the channel.

16. Glass Run Rear Channel

• Remove the bolt.
• Bolt is removed after removing door lock cylinder switch

harness. (Expect European Countries)

17. Door Lock Assembly

• Disconnect the lock cable from the anti rattler.
• Remove the 3 fixing screws and the bolt.
• Disconnect the linkage at the outside handle and the

lock cylinder.

• Disconnect the harness connector.

18.Outside Handle Protector (EUROPE)

• Remove the fixing bolt from the outside handle.

19. Outside Handle

20.Door Lock Cylinder Protector (EUROPE)

• Remove the fixing bolt from the outside handle.

21. Door Lock Cylinder

• Remove the 2 fixing bolts from the outside handle.

CAB 10-15

REASSEMBLY

This illustration is based on RHD model

RTW4A0LF000801

Reassembly Steps

1. Anti rattler

2. Door harness assembly

▲ 3. Door lock cylinder / Door lock cylinder

with door lock switch (European
Countries)

▲ 4. Door lock cylinder protector (EUROPE)
▲ 5. Outside handle
▲ 6. Outside handle protector (EUROPE)

7. Door lock assembly / Door lock

assembly with super lock

8. Glass run rear channel / Glass ran rear

channel with Door lock control or Anti
theft (European Countries)

9. Glass run

10. Window regulator / Power window

regulator

▲ 11. Window glass
12. Inside lever
13. Waterproof sheet
14. Speaker assembly
15.

Bracket

16. Outer waste seal
17. Door mirror assembly
18. Tweeter (Required option)
19. Door trim panel
20. Door mirror cover
21.

Bezel

22. Power window switch
▲ 23. Switch bezel / Window regulator handle

10-16 CAB

Important Operations

3. Door Lock Cylinder

• Tighten the door lock cylinder fixing bolts to the specified

torque.

Torque N

⋅m (kgf⋅m/lb⋅in)

9 (0.9/78)

4. Door Lock Cylinder Protector (EUROPE)

• Tighten the door lock cylinder protector fixing bolt to the

specified torque.

Torque N

⋅m (kgf⋅m/lb⋅in)

9 (0.9/78)

5. Outside Handle

• Tighten the outside handle fixing bolts to the specified

torque.

Torque N

⋅m (kgf⋅m/lb⋅in)

9 (0.9/78)

6. Outside Handle Protector (EUROPE)

• Tighten the outside handle protector fixing bolt to the

specified torque.

Torque N

⋅m (kgf⋅m/lb⋅in)

9 (0.9/78)

11. Window Glass

• Insert the window glass into position by tilting it as

necessary, then set it against the channel of the window

regulator.

• Attach the window glass to the window regulator with the

2 bolts.

CAB 10-17

23. Window Regulator Handle

• Install the regulator handle as illustrated when closing

the window glass.