Nissan Almera Tino V10. Manual — part 197
AT-512
[ALL]
ASSEMBLY
Assembly (3)
ECS009CY
1.
Remove reverse clutch assembly and install needle bearing on
high clutch assembly.
●
Pay attention to direction of needle bearing.
2.
Install reverse clutch assembly
3.
Install anchor end pin and lock nut on transmission case.
4.
Place brake band on outside of reverse clutch drum. Tighten
anchor end pin just enough so that brake band is evenly fitted on
reverse clutch drum.
5.
Place bearing race selected in total end play adjustment step on
oil pump cover.
●
Apply petroleum jelly to bearing race.
6.
Place thrust washer selected in reverse clutch end play step on
reverse clutch drum.
●
Apply petroleum jelly to thrust washer.
SAT387D
SAT038D
SAT389D
SAT390D
ASSEMBLY
AT-513
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
7.
Install oil pump assembly on transmission case.
8.
Tighten oil pump fixing bolts to the specified torque.
9.
Install O-ring to input shaft.
●
Apply ATF to O-ring.
10. Adjust brake band.
a.
Tighten anchor end pin to the specified torque.
b.
Back off anchor end pin two and a half turns.
SAT391D
SAT392D
SAT034D
Anchor end pin:
Refer to
AT-519, "SERVICE DATA AND SPECIFICA-
.
SAT394D
SAT395D
AT-514
[ALL]
ASSEMBLY
c.
While holding anchor end pin, tighten lock nut.
11. Apply compressed air to oil holes of transmission case and
check operation of brake band.
12. Install final drive assembly on transmission case.
13. Install differential lubricant tube on converter housing. Tighten
differential lubricant tube bolts to the specified torque. Refer to
.
14. Install O-ring on differential oil port of transmission case.
15. Install converter housing on transmission case.
●
Apply locking sealant to mating surface of converter
housing.
SAT396D
SAT397D
SAT030D
SAT063K
Bolt
Length mm (in)
A
32.8 (1.291)
B
40 (1.57)
SAT405D
ASSEMBLY
AT-515
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
16. Install accumulator piston.
a.
Check contact surface of accumulator piston for damage.
b.
Install O-rings on accumulator piston.
●
Apply ATF to O-rings.
c.
Install accumulator pistons and return springs on transmission
case.
●
Apply ATF to inner surface of transmission case.
17. Install lip seals for band servo oil holes on transmission case.
●
Apply petroleum jelly to lip seals.
SAT406DA
Accumulator piston O-rings:
Refer to
AT-519, "SERVICE DATA AND SPECIFICA-
.
SAT407DA
Return springs:
Refer to
AT-519, "SERVICE DATA AND SPECIFICA-
.
SAT878J
SAT021D
SAT022D
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст