Nissan Almera Tino V10. Manual — part 171
AT-408
[ALL]
KEY INTERLOCK CABLE
KEY INTERLOCK CABLE
PFP:34908
Components
ECS009C3
CAUTION:
●
Install key interlock cable in such a way that it will not be damaged by sharp bends, twists or inter-
ference with adjacent parts.
●
After installing key interlock cable to control device, make sure that casing cap and bracket are
firmly secured in their positions.
Removal
ECS009C4
1.
Unlock slider by squeezing lock tabs on slider from adjuster
holder and remove interlock rod from cable.
MCIA0115E
SAT246K
KEY INTERLOCK CABLE
AT-409
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
2.
Remove lock plate from steering lock assembly and remove key
interlock cable.
Installation
ECS009C5
1.
Turn ignition key to lock position.
2.
Set A/T selector lever to P position.
3.
Set key interlock cable to steering lock assembly and install lock
plate.
4.
Clamp cable to steering column and fix to control cable with
band.
5.
Insert interlock rod into adjuster holder.
6.
Install casing cap to bracket.
7.
Move slider in order to fix adjuster holder to interlock rod.
SAT247K
SAT247K
SAT248K
SAT249K
AT-410
[ALL]
ON-VEHICLE SERVICE
ON-VEHICLE SERVICE
PFP:00000
Control Valve Assembly and Accumulators
ECS009C6
REMOVAL
1.
Drain ATF from transaxle.
2.
Remove oil pan and gasket.
3.
Disconnect A/T solenoid valve harness connector.
4.
Remove snap ring from A/T solenoid valve harness terminal
body.
5.
Remove A/T solenoid valve harness by pushing terminal body
into transmission case.
SAT992C
MCIB9008E
AAT265A
ON-VEHICLE SERVICE
AT-411
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
6.
Remove control valve assembly by removing fixing bolts.
Bolt length, number and location:
●
Be careful not to drop manual valve and servo release accumulator return springs.
7.
Disassemble and inspect control valve assembly if necessary. Refer to
AT-410, "Control Valve Assembly
.
8.
Remove servo release and N-D accumulators by applying com-
pressed air if necessary.
●
Hold each piston with a rag.
INSTALLATION
●
Tighten fixing bolts to specification.
●
Set manual shaft in Neutral position, then align manual
plate with groove in manual valve.
●
After installing control valve assembly to transmission
case, make sure that selector lever can be moved to all
positions.
AAT260A
Bolt symbol
A
B
C
Bolt length “
” mm (in)
40.0 mm
(1.575 in)
33.0 mm
(1.299 in)
43.5 mm
(1.713 in)
Number of bolts
5
6
2
SAT935J
: 7 - 9 N-m (0.7 - 0.9 kg-m, 61 - 78 in-lb)
SAT497H
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст