Nissan Titan A60. Manual — part 664
ILLUMINATION
INL-77
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
INL
N
O
P
ILLUMINATION
Removal and Installation
INFOID:0000000006164489
ILLUMINATION CONTROL SWITCH
Removal
The illumination control switch (1) is replaced as a part of the combi-
nation meter assembly. Refer to
MWI-93, "Removal and Installation"
Installation
Installation is in the reverse order of removal.
CONSOLE ILLUMINATION LAMP (If Equipped)
Removal
The console illumination lamp is replaced as part of the front roof console assembly. Refer to
Installation
Installation is in the reverse order of removal.
Bulb Replacement
1. Remove front roof console. Refer to
INT-21, "Removal and Installation"
2. Rotate console illumination lamp bulb (1) counterclockwise, then
pull straight out away from room/map lamp assembly (2) to
remove.
ALLIA0329ZZ
ALLIA0327ZZ
INL-78
< SERVICE DATA AND SPECIFICATIONS (SDS)
BULB SPECIFICATIONS
SERVICE DATA AND SPECIFICATIONS (SDS)
BULB SPECIFICATIONS
Interior Lamp/Illumination
INFOID:0000000006164490
*: Always check with the Parts Department for the latest parts information.
Item
Wattage (W)*
Front room/map lamp (if equipped)
6
Room lamp (if equipped)
6
Vanity lamp (if equipped)
1.8
Step lamp (if equipped)
3.8
Personal lamp (if equipped)
8
Foot lamp (if equipped)
3.4
Console illumination lamp (if equipped)
*
INT-1
BODY INTERIOR
C
D
E
F
G
H
I
K
L
M
SECTION
INT
A
B
INT
N
O
P
CONTENTS
INTERIOR
SYMPTOM DIAGNOSIS . . . . . . . ...
SQUEAK AND RATTLE TROUBLE DIAG-
NOSES . . . . . . . . . . . . . . . .
Work Flow . . . . . . . . . . . . . . . .....
Generic Squeak and Rattle Troubleshooting . . ....
Diagnostic Worksheet . . . . . . . . . . . ...
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
Precaution for Work . . . . . . . . . . . . ..
PREPARATION . . . . . . . . . . .
PREPARATION . . . . . . . . . . . . ..
Special Service Tool . . . . . . . . . . . . .
Commercial Service Tool . . . . . . . . . . .
REMOVAL AND INSTALLATION . . . ...
DOOR FINISHER . . . . . . . . . . . ..
Removal and Installation . . . . . . . . . . .
BODY SIDE TRIM . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
FLOOR TRIM . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
HEADLINING . . . . . . . . . . . . .
INT-2
< SYMPTOM DIAGNOSIS >
SQUEAK AND RATTLE TROUBLE DIAGNOSES
SYMPTOM DIAGNOSIS
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
INFOID:0000000006158490
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diag-
nostic Worksheet during the interview to document the facts and conditions when the noise occurs and any
customer's comments; refer to
. This information is necessary to duplicate the
conditions that exist when the noise occurs.
• The customer may not be able to provide a detailed description or the location of the noise. Attempt to obtain
all the facts and conditions that exist when the noise occurs (or does not occur).
• If there is more than one noise in the vehicle, be sure to diagnose and repair the noise that the customer is
concerned about. This can be accomplished by test driving the vehicle with the customer.
• After identifying the type of noise, isolate the noise in terms of its characteristics. The noise characteristics
are provided so the customer, service adviser and technician are all speaking the same language when
defining the noise.
• Squeak —(Like tennis shoes on a clean floor)
Squeak characteristics include the light contact/fast movement/brought on by road conditions/hard surfaces
= higher pitch noise/softer surfaces = lower pitch noises/edge to surface = chirping.
• Creak—(Like walking on an old wooden floor)
Creak characteristics include firm contact/slow movement/twisting with a rotational movement/pitch depen-
dent on materials/often brought on by activity.
• Rattle—(Like shaking a baby rattle)
Rattle characteristics include the fast repeated contact/vibration or similar movement/loose parts/missing
clip or fastener/incorrect clearance.
• Knock —(Like a knock on a door)
Knock characteristics include hollow sounding/sometimes repeating/often brought on by driver action.
• Tick—(Like a clock second hand)
Tick characteristics include gentle contacting of light materials/loose components/can be caused by driver
action or road conditions.
• Thump—(Heavy, muffled knock noise)
Thump characteristics include softer knock/dead sound often brought on by activity.
• Buzz—(Like a bumble bee)
Buzz characteristics include high frequency rattle/firm contact.
• Often the degree of acceptable noise level will vary depending upon the person. A noise that you may judge
as acceptable may be very irritating to the customer.
• Weather conditions, especially humidity and temperature, may have a great effect on noise level.
DUPLICATE THE NOISE AND TEST DRIVE
SBT842
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст