Nissan Rogue. Manual — part 730
FRONT REGULATOR
GW-17
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
GW
N
O
P
5. Raise the front door glass and hold in place using a suitable tool
(A).
6. Disconnect the harness connector from the front power window motor.
7. Remove the bolts (A) and remove the front door glass regulator.
INSPECTION AFTER REMOVAL
Check the front door glass regulator for the following items:
• Wire wear
• Front door glass regulator deformation
• Grease condition for each sliding part
If a malfunction is detected, replace or grease it.
The arrows in the figure show the application points of the suitable
multi-purpose grease, if needed.
Inspection and Adjustment
INFOID:0000000011276514
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• When the main power window and door lock/unlock switch or front power window and door lock/
unlock switch RH is removed it is necessary to perform the initialization procedure. Refer to
28, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Special Repair
.
• Tighten front door regulator bolts to specification. Refer to
.
FITTING INSPECTION
• Check that the front door glass is fit securely into the glass run groove.
PIIB3510J
ALKIA2633ZZ
ALKIA3441ZZ
GW-18
< REMOVAL AND INSTALLATION >
FRONT REGULATOR
• Lower the front door glass slightly [approximately 10 to 20 mm (0.39 to 0.79) and check that the clearance to
the run is parallel.If the clearance between the glass and sash is not parallel, loosen the front door glass reg-
ulator bolts, front door glass run channel bolts, and glass and run rail bolts to correct the glass position.
FRONT POWER WINDOW MOTOR
GW-19
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
GW
N
O
P
FRONT POWER WINDOW MOTOR
Removal and Installation
INFOID:0000000011276515
REMOVAL
1. Remove front door glass regulator. Refer to
GW-16, "Removal and Installation"
.
2. Remove screws (A) and front power window motor (1) from front
door glass regulator (2).
INSTALLATION
Installation is in the reverse order of removal.
ALKIA3443ZZ
GW-20
< REMOVAL AND INSTALLATION >
REAR DOOR GLASS
REAR DOOR GLASS
Exploded View
INFOID:0000000011276516
Removal and Installation
INFOID:0000000011276517
REMOVAL
1. Remove the rear door finisher. Refer to
INT-18, "Removal and Installation"
.
2. Remove the rear door vapor barrier (1).
3. Temporarily reconnect the rear power window switch.
1. Rear door panel
2. Rear door glass corner finisher
3. Rear door glass rear run channel
4. Rear door glass regulator assembly 5. Rear door glass power window motor 6. Rear door glass
7. Rear door glass rubber run channel
AWKIA3206ZZ
ALKIA3481ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст