Nissan Rogue. Manual — part 731
REAR DOOR GLASS
GW-21
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
GW
N
O
P
4. Operate the rear power window switch to raise/lower the rear
door glass until the rear door glass regulator to rear door glass
bolts (A) can be seen and remove.
5. Partially remove rear door glass rubber run channel.
6. Remove screws and rear door corner finisher (1).
7. Remove the rear door glass (1).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• Tighten the rear door regulator bolts to glass specification. Refer to
FITTING INSPECTION
• Check that the rear door glass is securely fit into the rear door glass run channel.
• Lower the rear door glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)], and check that the clear-
ance to the sash is parallel. If the clearance between the rear door glass and sash is not parallel, loosen the
rear door regulator to glass bolts, rear door run channel bolts, and rear door glass bolts to correct the rear
door glass position.
ALKIA3482ZZ
ALKIA3483ZZ
ALKIA3484ZZ
GW-22
< REMOVAL AND INSTALLATION >
REAR REGULATOR
REAR REGULATOR
Exploded View
INFOID:0000000011276518
Removal and Installation
INFOID:0000000011276519
REMOVAL
1. Remove the rear door finisher. Refer to
INT-18, "Removal and Installation"
.
2. Remove rear door vapor barrier (1).
3. Temporarily reconnect the rear power window switch.
1. Rear door panel
2.
Rear door glass corner finisher
3. Rear door glass rear run channel
4. Rear door regulator assembly
5.
Rear door glass power window motor 6. Rear door glass
7. Rear door glass rubber run channel
AWKIA3206ZZ
ALKIA3481ZZ
REAR REGULATOR
GW-23
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
GW
N
O
P
4. Operate the rear power window switch to raise/lower the rear
door glass until the rear door glass regulator to rear door glass
bolts (A) can be seen and remove.
5. Raise the rear door glass and hold in place with suitable tool (A).
6. Remove the bolts (B) and nuts (A) from the rear door glass reg-
ulator (1).
7. Disconnect the harness connector from the rear door power win-
dow motor (1).
8. Remove rear door regulator (2).
INSPECTION AFTER REMOVAL
Check the rear door glass regulator for the following items:
• Gear wear
• Rear door glass regulator deformation
• Spring damage
• Grease condition for each sliding part
If a malfunction is detected, replace or grease it.
INSTALLATION
Installation is in reverse order of removal.
CAUTION:
ALKIA3482ZZ
PIIB3511J
ALKIA3486ZZ
ALKIA3487ZZ
GW-24
< REMOVAL AND INSTALLATION >
REAR REGULATOR
• Tighten the rear door regulator to specification Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст