Nissan Rogue. Manual — part 702
EVAP CANISTER FILTER
FL-23
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
M
A
FL
N
P
O
EVAP CANISTER FILTER
Exploded View
INFOID:0000000011279629
Removal and Installation
INFOID:0000000011279630
REMOVAL
1. Disconnect EVAP canister vent control valve hose from EVAP canister filter.
2. Disconnect canister drain hose from EVAP canister filter.
3. Remove the bolt and the EVAP canister filter.
INSTALLATION
Installation is in the reverse order of removal.
ALBIA1199ZZ
1.
EVAP canister vent control valve hose
2.
Canister drain hose
3.
Plug
4.
EVAP canister filter
Front
FL-24
< DISASSEMBLY AND ASSEMBLY >
FUEL LEVEL SENSOR UNIT
DISASSEMBLY AND ASSEMBLY
FUEL LEVEL SENSOR UNIT
Exploded View
INFOID:0000000011279631
Fuel Level Sensor Unit
Disassembly and Assembly
INFOID:0000000011279632
NOTE:
Fuel level sensor unit and fuel tank temperature sensor are replaced as and assembly.
DISASSEMBLY
1. Disconnect fuel level sensor unit/fuel tank temperature sensor
harness connector (1).
NOTE:
Hold connector with your fingers, because there is no tab for
releasing stopper. Pull harness connector straight downward.
ALBIA1198ZZ
1.
Fuel filter and pump assembly 2.
Fuel level sensor unit
3.
Float arm assembly
4.
Fuel tank temperature sensor
ALBIA1200ZZ
FUEL LEVEL SENSOR UNIT
FL-25
< DISASSEMBLY AND ASSEMBLY >
C
D
E
F
G
H
I
J
K
L
M
A
FL
N
P
O
2. Remove fuel tank temperature sensor (2) from fuel filter and fuel
pump assembly (1).
3. Using a suitable tool press up on clip (
) and remove fuel level
sensor unit (2) from fuel filter and fuel pump assembly (1).
CAUTION:
• Be careful not to damage the fuel level sensor unit.
• Do not disassemble fuel filter and fuel pump assembly.
ASSEMBLY
1. Slide fuel level sensor unit (1) until it aligns to installation groove
(A).
• After inserting, apply force in reverse direction (removal direc-
tion) to ensure it cannot be pulled out.
2. Connect fuel level sensor unit/fuel tank temperature sensor har-
ness connectors (1).
3. Check fuel level sensor unit installation position to fuel filter and pump assembly for damage. Replace as
necessary.
4. Assembly of remaining components is in the reverse order of disassembly.
INSPECTION AFTER INSTALLATION
Use the following procedure to check for fuel leaks.
1. Turn ignition switch “ON” (with engine stopped), then check connections for leaks by applying fuel pres-
sure to fuel piping.
2. Start engine and let it idle and check there are no fuel leaks at the fuel system connections.
ALBIA1201ZZ
ALBIA1202ZZ
ALBIA1222ZZ
ALBIA1200ZZ
FL-26
< SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Fuel Tank
INFOID:0000000011279633
Standard and Limit
Fuel tank capacity
Approx. 55 ( 14-1/2 US gal, 12-1/8 Imp gal)
Fuel recommendation
Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст