Nissan Rogue. Manual — part 565
COMPRESSION PRESSURE
EM-25
< PERIODIC MAINTENANCE >
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
• If two adjacent cylinders have respectively low compression pressure and their compression remains low
even after the addition of engine oil, the head gasket is leaking. In such a case, replace the cylinder head
gasket.
8. Install spark plug, ignition coil and harness connectors. Refer to
EM-19, "Removal and Installation"
.
EM-26
< REMOVAL AND INSTALLATION >
AIR CLEANER AND AIR DUCT
REMOVAL AND INSTALLATION
AIR CLEANER AND AIR DUCT
Exploded View
INFOID:0000000011279945
Removal and Installation
INFOID:0000000011279946
REMOVAL
1. Remove cowl top extension. Refer to
EXT-25, "Removal and Installation"
2. Remove air cleaner filter. Refer to
EM-18, "Removal and Installation"
.
3. Remove air duct assembly from air cleaner case (lower).
4. Remove air cleaner case (lower).
5. Disconnect harness connector from mass air flow sensor.
6. Remove air cleaner case (upper).
7. Remove mass air flow sensor from air cleaner case (upper) (if necessary).
CAUTION:
Handle the mass air flow sensor with care.
• Do not shock mass air flow sensor
• Do not disassemble mass air flow sensor
• Do not touch the internal sensor
1.
Mass air flow sensor
2.
Air cleaner filter
3.
Air cleaner case (lower)
4.
Air duct assembly (aft)
5.
Grommet
6.
Resonator bracket (front)
7.
Resonator bracket (rear)
8.
Resonator
9.
Air duct
10.
Mounting clip
11.
Air duct assembly (fore)
12.
Air cleaner case duct
13.
Air cleaner bracket
14.
Grommet
15.
Air cleaner case (upper)
A.
To Electric throttle control actuator
Front
AWBIA2315ZZ
AIR CLEANER AND AIR DUCT
EM-27
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
8. Separate air cleaner case (lower) (2) from air cleaner case duct
(1) and air duct assembly (fore) (3).
• Pull to the direction of the arrow and detach lock (B).
• Detach the snap fits (C).
• Lift up to separate the air cleaner case duct (1) from the air
cleaner case (lower) (2) and the air duct assembly (fore) (3).
INSTALLATION
Installation is in the reverse order of removal.
• Align mating marks (C) of air duct assembly (B) with air cleaner
case (upper) (A) as shown.
AWBIA2318ZZ
AWBIA2320ZZ
AWBIA1902ZZ
EM-28
< REMOVAL AND INSTALLATION >
AIR CLEANER AND AIR DUCT
• Align mating marks (C) of air duct assembly (A) with electric throt-
tle control actuator (B) as shown.
Inspection
INFOID:0000000011279947
INSPECTION AFTER REMOVAL
Inspect air duct and resonator assembly for cracks or tears.
• If anything found, replace air duct and resonator assembly.
AWBIA1903ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст