Nissan Rogue. Manual — part 405
DLN-64
< SYMPTOM DIAGNOSIS >
[TRANSFER: TY21C]
TIRE SIZE INCORRECT IS DISPLAYED ON INFORMATION DISPLAY
TIRE SIZE INCORRECT IS DISPLAYED ON INFORMATION DISPLAY
Description
INFOID:0000000011278352
While driving, AWD warning (Tire Size Incorrect: See Owner’s Manual) is displayed on information display
(combination meter).
Diagnosis Procedure
INFOID:0000000011278353
1.
CHECK TIRE
Check the following.
• Tire pressure
• Wear condition
• Front and rear tire size (There is no difference between front and rear tires.)
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace error-detected parts. And then, drive the vehicle at speed of 20 km/h (12 MPH)
or more for 5 seconds or more. Improper size information is initialized accordingly.
2.
CHECK INPUT SIGNAL OF TIRE DIAMETER
With CONSULT
1. Start the engine.
2. Drive at 20 km/h (12 MPH) or more for approximately 4 minutes continually.
3. Check “DIS-TIRE MONI” in “Data Monitor” of “ALL MODE AWD/4WD”.
Does the item on “Data Monitor” indicate “0 - 4 mm”?
YES
>> Inspection End.
NO
>> GO TO 3.
3.
TERMINAL INSPECTION
Check AWD control unit harness connector for disconnection.
Is the inspection result normal?
YES
>> Replace AWD control unit. Refer to
DLN-68, "Removal and Installation"
.
NO
>> Repair or replace the error-detected parts.
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
DLN-65
< SYMPTOM DIAGNOSIS >
[TRANSFER: TY21C]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
INFOID:0000000011278354
Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If nec-
essary, repair or replace these parts.
Reference
n"
—
"
"
n"
,
"
n"
,
"
SUSPECTED PARTS
(Possible cause)
T
R
ANSFER OIL (Level
low)
T
R
ANSFER OIL (W
rong)
T
R
ANSFER OIL (Level
too high)
LI
QUI
D
GASKET (Dam
ag
ed
)
O
-RING
(W
o
rn o
r da
m
age
d)
O
IL
SEA
L (W
o
rn o
r da
m
age
d)
GEAR
(W
orn
o
r
da
ma
ge
d)
B
EARING
(W
orn
or
da
ma
ge
d)
Symptom
Noise
1
2
3
3
3
Transfer oil leakage
3
1
2
2
2
DLN-66
< PERIODIC MAINTENANCE >
[TRANSFER: TY21C]
TRANSFER OIL
PERIODIC MAINTENANCE
TRANSFER OIL
Inspection
INFOID:0000000011278355
TRANSFER OIL LEAKS
Check that transfer oil is not leaking from transfer assembly or around it.
TRANSFER OIL LEVEL
CAUTION:
Do not start engine while checking transfer oil level.
1. Remove filler plug (1) and gasket.
2. Transfer oil level (A) should be level with bottom of filler plug
hole. Add transfer oil if necessary. Refer to
3. Set a new gasket onto filler plug, and install it in the transfer and
tighten to specified torque. Refer to
.
CAUTION:
Do not reuse gasket.
Draining
INFOID:0000000011278356
CAUTION:
Do not start engine while working.
1. Run the vehicle to warm up the transfer unit sufficiently.
2. Stop the engine and remove drain plug (1) and gasket and drain
the transfer oil.
3. Set a new gasket onto drain plug, and install it in the transfer
and tighten to specified torque. Refer to
.
CAUTION:
Do not reuse gasket.
Refilling
INFOID:0000000011278357
CAUTION:
Do not start engine while checking transfer oil level.
1. Remove filler plug (1).
2. Fill with new transfer oil to the specified level (A) near the filler
plug hole.
3. Set a new gasket onto filler plug, and install it in the transfer and tighten to specified torque. Refer to
: Front
ALDIA0560ZZ
: Front
AWDIA1153ZZ
: Front
Transfer oil grade and
viscosity
: Refer to
Transfer oil capacity
: Refer to
.
ALDIA0560ZZ
TRANSFER OIL
DLN-67
< PERIODIC MAINTENANCE >
[TRANSFER: TY21C]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
CAUTION:
Do not reuse gasket.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст