Nissan Qashqai J11. Manual — part 808
DLN-148
< SYMPTOM DIAGNOSIS >
[TRANSFER: TY30A]
AWD WARNING LAMP BLINKS QUICKLY
AWD WARNING LAMP BLINKS QUICKLY
Description
INFOID:0000000010288320
While driving, AWD warning lamp blinks 2 times in 1 second and it turns OFF after 1 minute.
• This symptom protects drive train parts when a heavy load is applied to the electric controlled coupling and
multiple disc clutch temperature increases. Also, optional distribution of torque sometimes becomes rigid
before lamp blinks quickly. Both cases are not malfunction.
• When this symptom occurs, stop vehicle and allow it to idle for some times. Blinking will stop and system will
be restored.
AWD WARNING LAMP BLINKS SLOWLY
DLN-149
< SYMPTOM DIAGNOSIS >
[TRANSFER: TY30A]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
AWD WARNING LAMP BLINKS SLOWLY
Description
INFOID:0000000010288321
AWD warning lamp blinks at approximately 2 seconds intervals while driving.
Diagnosis Procedure
INFOID:0000000010288322
1.
CHECK TIRE
Check the following.
• Tire pressure
• Wear condition
• Longitudinal tire size (There is no difference between longitudinal tires.)
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Drive at vehicle speed of 20 km/h (12 MPH) or more for 5 seconds or more after repairing or
replacing damaged parts. (Initialize improper size tire information.)
2.
CHECK INPUT SIGNAL OF TIRE DIAMETER
With CONSULT
1.
Start engine.
2.
Drive at 20 km/h (12 MPH) or more for approx. 200 seconds.
3.
Check “DIS-TIRE MONI” of AWD control unit CONSULT “DATA MONITOR”.
Does the item on “DATA MONITOR” indicate “0 - 4 mm”?
YES
>> INSPECTION END
NO
>> GO TO 3.
3.
TERMINAL INSPECTION
Check AWD control unit harness connector for disconnection.
Is the inspection result normal?
YES
>> Replace AWD control unit. Refer to
NO
>> Repair or replace the malfunctioning part.
DLN-150
< SYMPTOM DIAGNOSIS >
[TRANSFER: TY30A]
NORMAL OPERATING CONDITION
NORMAL OPERATING CONDITION
Description
INFOID:0000000010288323
While driving, AWD warning lamp blinks 2 times in 1 second and it turns OFF after 1 minute.
• This symptom protects drive train parts when a heavy load is applied to the electric controlled coupling and
multiple disc clutch temperature increases. Also, optional distribution of torque sometimes becomes rigid
before lamp blinks quickly. Both cases are not malfunction.
• When this symptom occurs, stop vehicle and allow it to idle for some times. Blinking will stop and system will
be restored.
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
DLN-151
< SYMPTOM DIAGNOSIS >
[TRANSFER: TY30A]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
INFOID:0000000010288324
M/T MODELS
Use the chart below to help you find the cause of the symptom. The numbers indicate the order of the inspec-
tion. If necessary, repair or replace these parts.
Reference
SUSPECTED PARTS
(Possible cause)
TRANSF
ER OIL (Level l
o
w)
TRANSF
ER OIL (W
rong)
T
R
ANSFER OI
L (L
ev
el
to
o h
ig
h
)
LIQUID GASKET
(Damaged)
O-RING (W
orn
or
da
ma
ge
d)
OIL SEAL (W
orn or
damaged)
GEAR (W
o
rn o
r da
m
a
g
ed)
BEAR
ING
(W
orn
o
r
da
ma
ge
d)
Symptom
Noise
1
2
3
3
3
Transfer oil leakage
3
1
2
2
2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст