Nissan Qashqai J11. Manual — part 872

WT-34

< DTC/CIRCUIT DIAGNOSIS >

[WITH TPMS]

C1708, C1709, C1710, C1711 TIRE PRESSURE SENSOR

C1708, C1709, C1710, C1711 TIRE PRESSURE SENSOR

DTC Description

INFOID:0000000010339527

DTC DETECTION LOGIC

NOTE:
The actual malfunction part may differ from the malfunction part which DTC shows if ID registration is not per-
formed after performing tire rotation or tire/road wheel replacement.

POSSIBLE CAUSE

• BCM harness or connector
• BCM
• Tire pressure sensor ID registration incomplete
• Tire pressure sensor is not attached.
• Tire pressure sensor
• Tire pressure sensor battery voltage
• Driving in area where radio wave cannot be transmitted/received.

DTC CONFIRMATION PROCEDURE

1.

TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to

WT-29, "Work Procedure"

.

Can the tire pressure sensor ID registration be completed?

YES

>> GO TO 2.

NO

>> Replace applicable tire pressure sensor. Refer to

WT-62, "Removal and Installation"

.

2.

PERFORM DTC CONFIRMATION

With CONSULT

1.

Drive the vehicle at 40 km/h (25 MPH) or more.
NOTE:
Avoid driving in area where radio wave cannot be transmitted/received.

2.

Stop the vehicle.

3.

Perform self-diagnosis for “AIR PRESSURE MONITOR”.

Is DTC “C1708”, “C1709”, “C1710” or “C1711” detected?

YES

>> Proceed to

WT-34, "Diagnosis Procedure"

.

NO

>> INSPECTION END

Diagnosis Procedure

INFOID:0000000010339528

1.

CHECK TIRE PRESSURE SIGNAL

With CONSULT

1.

Select “DATA MONITOR” in “AIR PRESSURE MONITOR”.

2.

Check the values that are displayed for “AIR PRESS FL”, “AIR PRESS FR”, “AIR PRESS RR”, and “AIR
PRESS RL”.
NOTE:
BCM holds last tire pressure values during 17 minutes after ignition switch turns OFF.

Are all tire pressures displayed 0 kPa (psi)?

DTC No.

CONSULT screen item

(Trouble diagnosis content)

DTC Detection Condition

C1708

[NO - DATA] - FL
(No data front left)

Tire pressure data signal from the front left wheel tire pressure sensor cannot be
detected.

C1709

[NO - DATA] - FR
(No data front right)

Tire pressure data signal from the front right wheel tire pressure sensor cannot
be detected.

C1710

[NO - DATA] - RR
(No data rear right)

Tire pressure data signal from the rear right wheel tire pressure sensor cannot be
detected.

C1711

[NO - DATA] - RL
(No data rear left)

Tire pressure data signal from the rear left wheel tire pressure sensor cannot be
detected.

C1708, C1709, C1710, C1711 TIRE PRESSURE SENSOR

WT-35

< DTC/CIRCUIT DIAGNOSIS >

[WITH TPMS]

C

D

F

G

H

I

J

K

L

M

A

B

WT

N

O

P

YES

>> GO TO 2.

NO

>> Replace applicable tire pressure sensor. Refer to

WT-62, "Removal and Installation"

.

2.

TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to

WT-29, "Work Procedure"

.

Can the tire pressure sensor ID registration be completed?

YES

>> GO TO 3.

NO

>> Replace applicable tire pressure sensor. Refer to

WT-62, "Removal and Installation"

.

3.

CHECK BCM POWER SUPPLY CIRCUIT

Check BCM power supply circuit. Refer to

BCS-125, "Diagnosis Procedure"

.

Is the inspection result normal?

YES

>> Replace the BCM. Refer to

BCS-132, "Removal and Installation"

.

NO

>> Repair or replace harness or connectors.

WT-36

< DTC/CIRCUIT DIAGNOSIS >

[WITH TPMS]

C1716, C1717, C1718, C1719 TIRE PRESSURE SENSOR

C1716, C1717, C1718, C1719 TIRE PRESSURE SENSOR

DTC Description

INFOID:0000000010339529

DTC DETECTION LOGIC

NOTE:
The actual malfunction part may differ from the malfunction part which DTC shows if ID registration is not per-
formed after performing tire rotation or tire/road wheel replacement.

POSSIBLE CAUSE

• Tire pressure sensor
• BCM

DTC CONFIRMATION PROCEDURE

1.

PERFORM SELF DIAGNOSTIC RESULT

With CONSULT

1.

Turn the ignition switch ON.

CAUTION:

Never start the engine.

2.

Check tire pressure for all wheels and adjust to the specified value. Refer to

WT-66, "Tire Air Pressure"

.

3.

Perform self-diagnosis for “AIR PRESSURE MONITOR”.

Is DTC C1716, C1717, C1718, or C1719 detected?

YES

>> Proceed to

WT-36, "Diagnosis Procedure"

.

NO-1

>> To check malfunction symptom before repair: Refer to

GI-41, "Intermittent Incident"

.

NO-2

>> Confirmation after repair: INSPECTION END

Diagnosis Procedure

INFOID:0000000010339530

1.

TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to

WT-29, "Work Procedure"

.

Can the tire pressure sensor ID registration be completed?

YES

>> Perform “DTC CONFIRMATION PROCEDURE” (self-diagnosis) again. Refer to

WT-36, "DTC

Description"

.

NO

>> Replace applicable tire pressure sensor. Refer to

WT-62, "Removal and Installation"

.

DTC No.

CONSULT screen item

(Trouble diagnosis content)

DTC Detection Condition

C1716

[PRESSDATA ERR] FL
(Pressure data error front left)

Malfunction in the tire pressure data from the front left wheel tire pressure sensor.

C1717

[PRESSDATA ERR] FR
(Pressure data error front right)

Malfunction in the tire pressure data from the front right wheel tire pressure sen-
sor.

C1718

[PRESSDATA ERR] RR
(Pressure data error rear right)

Malfunction in the tire pressure data from the rear right wheel tire pressure sen-
sor.

C1719

[PRESSDATA ERR] RL
(Pressure data error rear left)

Malfunction in the tire pressure data from the rear left wheel tire pressure sensor.

C1729 VEHICLE SPEED SIGNAL

WT-37

< DTC/CIRCUIT DIAGNOSIS >

[WITH TPMS]

C

D

F

G

H

I

J

K

L

M

A

B

WT

N

O

P

C1729 VEHICLE SPEED SIGNAL

DTC Description

INFOID:0000000010339531

DTC DETECTION LOGIC

POSSIBLE CAUSES

• CAN communication
• BCM
• ABS actuator and electric unit (control unit) malfunction

DTC CONFIRMATION PROCEDURE

1.

DTC CONFIRMATION PROCEDURE

With CONSULT

1.

Drive the vehicle.

2.

Stop the vehicle.

3.

Perform self-diagnosis in “AIR PRESSURE MONITOR”.

Is DTC “C1729” detected?

YES

>> Proceed to

WT-37, "Diagnosis Procedure"

.

NO

>> INSPECTION END

Diagnosis Procedure

INFOID:0000000010339532

1.

PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS

With CONSULT

Perform self-diagnosis for “ABS”.

Is any DTCs detected?

YES

>> Check the DTCs.

NO

>> GO TO 2.

2.

CHECK BCM INPUT/OUTPUT SIGNAL

Check BCM input/output signal values. Refer to

BCS-64, "Reference Value"

.

Is the inspection result normal?

YES

>> Check pin terminal and connection of each harness connector for malfunctioning conditions.

NO

>> Replace the BCM. Refer to

BCS-132, "Removal and Installation"

.

DTC No.

CONSULT screen item

(Trouble diagnosis content)

DTC Detection Condition

C1729

VHCL SPEED SIG ERR
(Vehicle speed signal error)

Vehicle speed signal not detected.