Nissan Qashqai J11. Manual — part 1799
WW-74
< SYMPTOM DIAGNOSIS >
FRONT WIPER DOES NOT OPERATE
YES
>> Replace BCM. Refer to
BCS-132, "Removal and Installation"
.
NO
>> Repair or replace the applicable parts.
FRONT WIPER
WW-75
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
REMOVAL AND INSTALLATION
FRONT WIPER
Exploded View
INFOID:0000000010479826
WIPER ARM
WIPER ARM : Removal and Installation
INFOID:0000000010479827
CAUTION:
Clean the windshield glass and wiper refill so that the windshield glass may not be damaged by dust,
etc.
REMOVAL
1.
Full open hood assembly.
CAUTION:
Before opening hood assembly, check that wipers are in auto stop position.
2.
Remove wiper arm cap.
3.
Remove wiper arm fixing nut, and then remove wiper arm.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
Wiper blade RH
Wiper refill RH
Wiper arm RH
Wiper motor assembly
Wiper arm cap
Wiper arm LH
Wiper refill LH
WIper blade LH
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
: Nissan MP special grease No. 2
JMLIA5158GB
W
W
- 7
6
< REMOVAL AND INSTALLATION >
FRONT WIPER
• Clean wiper arm installation location as shown in the figure,
and then fully insert wiper arm to prevent nut from being loos-
ened by shakiness.
• When installing the wiper arm, install so that it is within the standard. For the standard, refer to
.
• After installation, operate front wiper, and then check that the wiper blades stop at the specified
position. Refer to
WW-76, "WIPER ARM : Adjustment"
.
WIPER ARM : Adjustment
INFOID:0000000010479828
WIPER BLADE POSITION ADJUSTMENT
Clearance between the end of cowl top cover / front fender cover and the top of wiper blade center.
Standard clearance
WIPER BLADE
WIPER BLADE : Removal and Installation
INFOID:0000000010479829
CAUTION:
Clean the windshield glass and wiper refill so that the windshield glass may not be damaged by dust,
etc.
REMOVAL
1.
Move the wiper arm by service position operation to lock back possibility position.
• with light & rain sensor: Refer to
WW-10, "FRONT WIPER AND WASHER SYSTEM (WITH LIGHT &
RAIN SENSOR) : System Description"
.
• without light & rain sensor: Refer to
WW-13, "FRONT WIPER AND WASHER SYSTEM (WITHOUT
LIGHT & RAIN SENSOR) : System Description"
ELH0717D
Windshield glass assembly
Wiper blade RH
Cowl top cover
Wiper blade LH
Wiper arm RH
JMLIA5159ZZ
S
: 38.0
±
7.5 mm (1.50
±
0.30 in)
M : 40.7
±
7.5 mm (1.60
±
0.30 in)
FRONT WIPER
WW-77
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
2.
Lift up wiper arm, and then lock back wiper arm.
3.
Slide the wiper blade while pushing up lever
, and then
remove wiper blade.
CAUTION:
After the wiper blade is removed, wrap the wiper arm tip
with a shop cloth and fold it down so that the wiper arm
does not fall against and damage the windshield glass.
INSTALLATION
Install in the reverse order of removal.
WIPER REFILL
WIPER REFILL : Removal and Installation
INFOID:0000000010479830
REMOVAL
1.
Remove wiper blade. Refer to
WW-76, "WIPER BLADE : Removal and Installation"
2.
Pull out wiper refill using a long-nose pliers (A), and then
remove wiper refill.
INSTALLATION
1.
Check the wiper refill insertion direction by arrow mark on wiper
blade.
2.
Pass through pawl of wiper blade in the groove of wiper refill.
NOTE:
Remove holder
* at last procedure.
*: Attached to service parts.
JMLIA4149ZZ
JMLIA4385ZZ
JMLIA2606ZZ
JMLIA4386ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст