Nissan Terrano model r20 series 2004. Manual — part 285
FINAL DRIVE SIDE
— TS82F type —
1. Install new small boot band, boot and side joint housing to drive
shaft.
Cover drive shaft serration with tape so as not to damage boot
during installation.
2. Install spider assembly securely, ensuring marks are properly
aligned.
I
Press-fit with spider assembly serration chamfer facing
shaft.
3. Install new snap ring.
4. Pack with grease.
Specified amount of grease:
190 - 210 g (6.70 - 7.41 oz)
5. Set boot so that it does not swell and deform when its length is
“L”.
Length “L” = 102 - 104 mm (4.02 - 4.09 in)
Make sure that boot is properly installed on the drive shaft
groove.
6. The rubber cover comes with clamps on both ends. Firmly
clinch the clamp to the end which is wider in diameter and
repeat the procedure at the narrower end. Use the appropriate
tool.
SFA800
SFA397
SFA882
SFA883
SFA395
FRONT AXLE — Drive Shaft
Assembly (Cont’d)
FA-26
7. Install new plug seal to slide joint housing by lightly tapping it.
Apply sealant to mating surface of plug seal.
WHEEL SIDE (ZF100)
1. Install new small boot band and boot on drive shaft.
Cover drive shaft serration with tape so as not to damage boot
during installation.
2. Set joint assembly onto drive shaft by lightly tapping it.
Install joint assembly securely, ensuring marks which were
made during disassembly are properly aligned.
3. Pack drive shaft with specified amount of grease.
Specified amount of grease:
100 - 120 g (3.53 - 4.23 oz)
4. Set boot so that is does not swell and deform when its length
is “L”.
Length “L” = 96 - 98 mm (3.78 - 3.86 in)
Make sure that boot is properly installed on the drive shaft
groove.
SFA472
SFA800
SFA884
SFA885
YFA011
FRONT AXLE — Drive Shaft
Assembly (Cont’d)
FA-27
5. Lock new larger boot band securely with a suitable tool.
Installation
I
Apply multi-purpose grease.
I
Install bearing spacer onto drive shaft.
Make sure that bearing spacer is facing in proper direction.
I
When installing drive shaft, adjust drive shaft axial end play by
selecting a suitable snap ring.
(1) Temporarily install new snap ring on drive shaft in the same
thickness as it was installed before removal.
(2) Set dial gauge on drive shaft end.
(3) Measure axial end play of drive shaft.
Axial end play: 0.1 - 0.3 mm (0.004 - 0.012 in)
(4) If axial end play is not within the specified limit, select another
snap ring.
1.1 mm (0.043 in)
1.3 mm (0.051 in)
1.5 mm (0.059 in)
1.7 mm (0.067 in)
1.9 mm (0.075 in)
2.1 mm (0.083 in)
2.3 mm (0.091 in)
SFA395
YFA012
YFA013
SFA940
NFA013
FRONT AXLE — Drive Shaft
Assembly (Cont’d)
FA-28
NFA038
FRONT SUSPENSION
FA-29
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст