Nissan Primera P11. Manual — part 68
Wagon
NBT055
Glass
Pin
.
A-A
Glass side
16 (0.6)
Primer portion
Glass
B-B
Body side
17 (0.7)
Primer
portion
C-C
Unit: mm (in)
Glass
Sealant
7 (0.28)
12 (0.47)
4.5 (0.2)
2 (0.1)
Back door molding
Back door mold-
ing
WINDSHIELD AND WINDOWS
Back Door Window (Cont’d)
BT-57
Door Mirror
CAUTION:
Be careful not to scratch door rearview mirror body.
★
For Wiring Diagram, refer to “POWER DOOR MIRROR” in EL section.
REMOVAL — Door mirror
p
1
Remove door trim. Refer to “Door Trim” for details, BT-24.
p
2
Remove inner cover from front corner of door.
p
3
Disconnect door mirror harness connector.
p
4
Remove bolts securing door mirror, then remove door mirror assembly.
YBT036
SEC. 963
Pawl
Removal:
●
Wrap flat-blade of screwdriver with a cloth to prevent scratching.
Do not insert too far. Push mirror away from car to release.
Mirror
Cloth
Flat-bladed
screwdriver
Inside
Outside
MIRROR
BT-58
Rearview Mirror
REMOVAL
Remove rearview mirror by pushing deflect spring with screw-
driver as shown in the figure.
INSTALLATION
1. Install mounting bracket as follows:
(1) Determine mounting bracket position on windshield by mea-
suring from top of windshield to top of mounting bracket as
shown in the figure.
(2) Mark location on outside of windshield with wax pencil or
equivalent.
(3) Clean attaching point on inside of windshield with an alcohol-
saturated paper towel.
(4) Sand bonding surface of mounting bracket with sandpaper
(No. 320 or No. 360).
(5) Clean bonding surface of mounting bracket with an alcohol-
saturated paper towel.
(6) Apply Loctite Adhesive 11067-2 or equivalent to bonding sur-
face of mounting bracket.
(7) Install mounting bracket at premarked position and press
mounting bracket against glass for 30 to 60 seconds.
(8) After five minutes, wipe off excess adhesive with an alcohol-
moistened paper towel.
2. Install rearview mirror.
NBT059
Windshield
Mirror assembly
Windshield
Mounting
bracket
Mounting
bracket
Side view
Mirror assembly
YBT049
Bracket
Center of windshield
85 - 90 mm
(3.34 - 3.54 in)
Mounting bracket location
MIRROR
BT-59
●
All dimensions indicated in figures are actual ones.
●
When using a tracking gauge, adjust both pointers to equal length. Then check the pointers and gauge
itself to make sure there is no free play.
●
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
●
Measurements should be taken at the center of the mounting holes.
●
An asterisk (*) following the value at the measuring point indicates that the measuring point on the other
side is symmetrically the same value.
●
The coordinates of the measurement points are the distances measured from the standard line of “X”,
“Y” and “Z”.
Engine Compartment
MEASUREMENT
SBF874GB
Imaginary base line
Front axle center
Vehicle center
“Z”: Imaginary base line
[200 mm below datum line
(“0Z” at design plan)]
YBT038
Unit: mm
BODY ALIGNMENT
BT-60
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст