Nissan Pathfinder. Manual — part 1183
CONTROL CABLE
TM-191
< REMOVAL AND INSTALLATION >
[CVT: RE0F10E]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
CONTROL CABLE
Exploded View
INFOID:0000000009177649
Removal and Installation
INFOID:0000000009177650
INSTALLATION
CAUTION:
Always apply the parking brake before performing removal and installation.
1. Remove the front air duct and air cleaner case assembly. Refer to
EM-24, "Removal and Installation"
.
2. Remove the control cable nut from the manual lever.
3. Remove the lock plate (1).
4. Remove center console upper side finisher (LH). Refer to
.
1.
Bracket B
2.
Lock plate
3.
Transaxle assembly
4.
Bracket A
5.
Control cable
6.
CVT shift selector assembly
A: Manual lever
B: Grommet
ALDIA0352GB
JSDIA1812ZZ
TM-192
< REMOVAL AND INSTALLATION >
[CVT: RE0F10E]
CONTROL CABLE
5. Release center console side finisher (LH/RH) clip and pawls
using a suitable tool and remove.
: Clip
: Pawl
: Front
6. Release shift selector finisher clips and pawls using a suitable tool, disconnect the harness connectors
and remove. Refer to
7. Remove the control cable from the CVT shift selector assembly.
8. Remove the bolts (1) from the grommet (2).
9. Remove the control cable from the vehicle.
INSTALLATION
Installation is in the reverse order of removal.
• Pay attention to the following when connecting the control cable to the CVT shift selector.
1. When connecting the control cable (1) to the CVT shift selector
assembly (2), face the grooved surface of the rib (A) up and
insert the control cable until it stops.
2. Install the socket (A) onto the CVT shift selector.
CAUTION:
• Place the socket onto the CVT shift lever, then fasten it in
place from above.
• Check that pulling on the socket does not disconnect it.
Inspection and Adjustment
INFOID:0000000009177651
INSPECTION AFTER INSTALLATION
ALJIA1257ZZ
(3)
: Control cable
: Front
ALDIA0394ZZ
JSDIA1624ZZ
JSDIA1810ZZ
CONTROL CABLE
TM-193
< REMOVAL AND INSTALLATION >
[CVT: RE0F10E]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
Check the CVT position. If a malfunction is found, adjust the CVT position. Refer to
TM-194
< REMOVAL AND INSTALLATION >
[CVT: RE0F10E]
TOW MODE SWITCH
TOW MODE SWITCH
Removal and Installation
INFOID:0000000009177652
REMOVAL
1. Remove instrument lower panel (LH). Refer to
IP-25, "Removal and Installation"
2. Remove screws (1) from the bracket.
3. Remove tow mode switch.
INSTALLATION
Installation is in the reverse order of removal.
ALDIA0395ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст