Nissan Pathfinder. Manual — part 388
DLK-318
< REMOVAL AND INSTALLATION >
BACK DOOR WARNING CHIME
BACK DOOR WARNING CHIME
Removal and Installation
INFOID:0000000009744485
REMOVAL
1. Remove the rear bumper fascia. Refer to
EXT-20, "Removal and Installation"
2. Remove the back door warning chime bracket nut (A) and
remove back door warning chime (1).
3. Remove back door warning chime (1) from bracket (2) (if neces-
sary).
INSTALLATION
Installation is in the reverse order of removal.
ALKIA3219ZZ
REMOTE KEYLESS ENTRY RECEIVER
DLK-319
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
REMOTE KEYLESS ENTRY RECEIVER
Removal and Installation
INFOID:0000000009175919
REMOVAL
1. Remove the glove box assembly. Refer to
IP-26, "Removal and Installation"
2. Remove the remote keyless entry receiver bolt.
3. Disconnect the harness connector from remote keyless entry receiver and remove.
INSTALLATION
Installation is in the reverse order of removal.
DLK-320
< REMOVAL AND INSTALLATION >
INTELLIGENT KEY BATTERY
INTELLIGENT KEY BATTERY
Removal and Installation
INFOID:0000000009175920
1. Release the lock knob on the back of the Intelligent Key and remove the key.
2. Insert a suitable tool (A) wrapped with a cloth into the slit of the
corner and twist it to separate the upper part from the lower part.
CAUTION:
• Do not insert a tool into the notches of the Intelligent Key
to pry it open, as this may damage the circuit board.
• Do not use excessive force when opening the intelligent
key, as this may result in damage to the internal compo-
nents.
• Do not touch the circuit board or battery terminal.
• The key fob is water-resistant. However, if it does get wet,
immediately wipe it dry.
3. Replace the battery with a new one.
4. Align the tips of the upper and lower parts, and then push them
together until unit is securely closed.
CAUTION:
• When replacing battery, keep dirt, grease, and other for-
eign materials off the electrode contact area.
• After replacing the battery, check that all Intelligent Key
functions work normally.
PIIB6221E
Battery replacement
:Coin-type lithium battery
(CR2025)
PIIB6222E
AUTOMATIC BACK DOOR CONTROL MODULE
DLK-321
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
AUTOMATIC BACK DOOR CONTROL MODULE
Removal and Installation
INFOID:0000000009175921
REMOVAL
1. Remove the luggage side lower finisher (LH). Refer to
INT-31, "LUGGAGE SIDE LOWER FINISHER :
.
2. Remove the automatic back door control module bolts.
3. Disconnect the harness connector from the automatic back door control module and remove.
INSTALLATION
Installation is in the reverse order of removal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст