Nissan Pathfinder. Manual — part 90
AV
AV CONTROL UNIT
AV-187
< REMOVAL AND INSTALLATION >
[MID AUDIO WITHOUT BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
REMOVAL AND INSTALLATION
AV CONTROL UNIT
Exploded View
INFOID:0000000009174497
Removal and Installation
INFOID:0000000009174498
REMOVAL
CAUTION:
• Remove battery terminal and AV control unit after a lapse of 30 seconds or more after turning the
ignition switch OFF.
• Before replacing AV control unit, perform "READ CONFIGURATION" to save current vehicle specifi-
cation. Refer to
AV-118, "CONFIGURATION (AV CONTROL UNIT) : Configuration List"
NOTE:
After the ignition switch is turned OFF, the AV control unit continues operating for approximately 30 seconds.
Therefore, data corruption may occur if battery voltage is cut off within 30 seconds.
1. Disconnect the negative battery terminal. Refer to
PG-90, "Removal and Installation"
2. Remove cluster lid C. Refer to
IP-22, "CLUSTER LID C : Removal and Installation"
3. Remove the screws, then pull out the AV control unit.
4. Disconnect the harness connectors from the AV control unit and remove.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
1.
AV control unit bracket (LH)
2.
A/C auto amp.
3.
AV control unit
4.
AV control unit bracket (RH)
ALNIA1436ZZ
AV-188
< REMOVAL AND INSTALLATION >
[MID AUDIO WITHOUT BOSE]
AV CONTROL UNIT
• When replacing AV control unit, perform "WRITE CONFIGURATION". Refer to
AV
A/C AND AV SWITCH ASSEMBLY
AV-189
< REMOVAL AND INSTALLATION >
[MID AUDIO WITHOUT BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
A/C AND AV SWITCH ASSEMBLY
Removal and Installation
INFOID:0000000009174499
REMOVAL
1. Remove cluster lid C lower. Refer to
IP-22, "CLUSTER LID C LOWER : Removal and Installation"
2. Remove the A/C and AV switch assembly lower screws.
3. Release upper pawls and remove A/C and AV switch assembly.
INSTALLATION
Installation is in the reverse order of removal.
AV-190
< REMOVAL AND INSTALLATION >
[MID AUDIO WITHOUT BOSE]
STEERING SWITCH
STEERING SWITCH
Exploded View
INFOID:0000000009174500
Removal and Installation
INFOID:0000000009174501
REMOVAL
NOTE:
The steering switches are serviced as an assembly.
1. Remove steering wheel. Refer to
ST-44, "Removal and Installation"
.
2. Release pawls and remove steering wheel rear finisher (1) from
steering wheel (2).
3. Remove steering switches screws.
4. Remove steering switches (1) from steering wheel (2).
INSTALLATION
Installation is in the reverse order of removal.
1.
Steering switches
2.
Steering wheel
3.
Steering wheel rear finisher
ALOIA0025ZZ
ALOIA0026ZZ
ALOIA0027ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст