Nissan X-Trail 32. Manual — part 716
DMS-12
< WIRING DIAGRAM >
[ECO MODE]
ECO MODE SYSTEM
JROWC2865GB
DMS
ECO MODE SYSTEM
DMS-13
< WIRING DIAGRAM >
[ECO MODE]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
JROWC2866GB
DMS-14
< BASIC INSPECTION >
[ECO MODE]
DIAGNOSIS AND REPAIR WORK FLOW
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
INFOID:0000000010623751
DETAILED FLOW
1.
OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the conditions and environment under
which the malfunction occurs.
>> GO TO 2.
2.
CHECK SYMPTOM
• Check the symptom based on the information obtained from the customer.
• Check if any other malfunctions are present.
>> GO TO 3.
3.
DTC/SYSTEM DIGANOSIS
Perform a DTC/system diagnosis and repair or replace any malfunctioning part.
>> GO TO 4.
4.
FINAL CHECK
Check that the ECO mode functions normally.
Does it operation normally?
YES
>> End of trouble diagnosis
NO
>> GO TO 2.
DMS
ECO MODE SWITCH
DMS-15
< DTC/CIRCUIT DIAGNOSIS >
[ECO MODE]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
DTC/CIRCUIT DIAGNOSIS
ECO MODE SWITCH
Component Function Check
INFOID:0000000010623752
1.
CHECK ECO MODE SWITCH OPERATION
1.
Turn ignition switch ON.
2.
Check ECO mode indicator turns ON/OFF on combination meter when turn ECO mode switch ON/OFF.
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> Go to
.
Diagnosis Procedure
INFOID:0000000010623753
1.
DETECT MALFUNCTIONING ITEMS
What is malfunction item?
ECO mode switch illumination does not turn ON>>GO TO 2.
ECO mode indicator does not turn ON>>GO TO 7.
2.
CHECK ECO MODE SWITCH ILLUMINATION POWER SUPPLY (PART 1)
1.
Turn OFF the headlamp.
2.
Turn ignition switch OFF.
3.
Disconnect ECO mode switch harness connector.
4.
Turn ignition switch ON.
5.
Turn ON the headlamp.
6.
Check the voltage between ECO mode switch harness connector terminals.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> GO TO 4.
3.
CHECK INTERMITTENT INCIDENTE
GI-44, "Intermittent Incident"
.
Is the inspection result normal?
YES
>> Replace ECO mode switch. Refer to
DMS-19, "Removal and Installation"
NO
>> Replace the fuse after repair the applicable circuit.
4.
CHECK ECO MODE SWITCH ILLUMINATION POWER SUPPLY (PART 2)
Check the voltage between ECO mode switch harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 6.
NO
>> GO TO 5.
ECO mode switch
Voltage
(Approx.)
Connector
+
–
Terminal
M9
3
4
12 V
+
−
Voltage
(Approx.)
ECO mode switch
Connector
Terminal
M9
3
Ground
12 V
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст