Nissan Terrano r20e. Manual — part 379
Commercial Service Tools
Tool name
Description
Puller
NT077
Removing counter gear rear end bearing
Removing mainshaft rear bearing
Removing reverse synchronizer hub
Removing reverse counter gear
Drift
ST22452000
a: 44.5 mm (1.752 in) dia.
b: 38.5 mm (1.516 in) dia.
Installing sub-gear snap ring
Drift
ST22452000
a: 44.5 mm (1.752 in) dia.
b: 40.5 mm (1.594 in) dia.
Installing OD main gear
Installing reverse gear bushing
PREPARATION
MT-4
Replacing the Rear Oil Seal
REMOVAL
1. Remove transfer assembly. See Section TF.
2. Remove rear oil seal.
REPLACEMENT
1. Install rear oil seal.
Before installation, apply multi-purpose grease to oil seal lip.
2. Install transfer assembly. See Section TF.
SMT321B
SMT453B
TRANSMISSION FS5R30A
MT-5
Check of Position Switches
Switch
Gear position
Continuity
q
1
4WD*
Transfer case
4WD
Yes
Except 4WD
No
q
2
Back-up lamp
Transmission
case
Reverse
Yes
Except reverse
No
*: Ensure both sides of 4WD 2-pole double-throw switch is operational, refer to
“Warning lamps” wiring diagram in EL-Section.
YMT009
ON-VEHICLE SERVICE
FS5R30A
MT-6
Removal
Transmission has to be removed as a unit together with transfer
box.
Remove transmission assembly as follows:
I
Disconnect negative battery terminal.
I
Remove shift levers of transmission and transfer.
I
Remove front and rear propeller shafts. — Refer to PD section.
I
Insert plug into rear oil seal after removing propeller shaft.
I
Remove RPM-sensor from transmission upper side.
CAUTION:
Be careful not to damage spline, sleeve yoke and rear oil seal,
when removing propeller shaft.
I
Remove torsion bar spring. — Refer to FA Section.
I
Remove third crossmember (the one supporting front differen-
tial).
I
Remove fifth crossmember (the one situated at the rear of
transfer).
I
Support transmission and transfer with a suitable transmission
jack.
WARNING:
Support transmission and transfer with suitable jacks, while
removing them.
I
Remove fourth crossmember (the one supporting transmis-
sion).
I
Remove clutch operating cylinder.
I
Remove starter motor.
I
Remove exhaust tube bracket from transmission.
I
Disconnect electrical connectors.
I
Remove transmission from engine.
REMOVAL AND INSTALLATION
FS5R30A
MT-7
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст