Nissan Titan. Manual — part 137
DLN-120
< UNIT DISASSEMBLY AND ASSEMBLY >
[TRANSFER: TX15B]
PLANETARY CARRIER
5. Install the sun gear assembly to the planetary carrier assembly.
6. Install the new snap ring to the planetary carrier assembly.
CAUTION:
Do not reuse snap ring.
SDIA2794E
FRONT DRIVE SHAFT
DLN-121
< UNIT DISASSEMBLY AND ASSEMBLY >
[TRANSFER: TX15B]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
FRONT DRIVE SHAFT
Disassembly and Assembly
INFOID:0000000009886041
DISASSEMBLY
1. Remove the front bearing using Tools.
2. Remove the rear bearing using Tools.
INSPECTION AFTER DISASSEMBLY
Front Drive Shaft
Check the items below. If necessary, replace them with new ones.
• Damage, peeling, dent, uneven wear and bending of the shaft.
• Excessive wear, damage and peeling of the gear.
Bearing
Check the bearing for damage and rough rotation. If necessary,
replace the bearing with a new one.
ASSEMBLY
Tool number
(A): ST35300000 ( — )
(B): ST30021000 (J-22912-01)
SDIA2106E
Tool number
(A): ST33710000 ( — )
(B): ST30021000 (J-22912-01)
PDIA0153E
PDIA0154E
MTF0041D
DLN-122
< UNIT DISASSEMBLY AND ASSEMBLY >
[TRANSFER: TX15B]
FRONT DRIVE SHAFT
1. Install the rear bearing using Tools.
2. Install the front bearing using Tools.
Tool number
(A): KV38100500 ( — )
(B): ST30901000 (J-26010-01)
PDIA0155E
Tool number
(A): KV38100500 ( — )
(B): ST30901000 (J-26010-01)
PDIA0156E
SHIFT CONTROL
DLN-123
< UNIT DISASSEMBLY AND ASSEMBLY >
[TRANSFER: TX15B]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
SHIFT CONTROL
Disassembly and Assembly
INFOID:0000000009886042
DISASSEMBLY
1. Remove the snap ring.
CAUTION:
Do not reuse snap ring.
2. Remove the retaining pin.
CAUTION:
Do not reuse retaining pin.
3. Remove the drum cam from the control shift rod.
4. Remove the retaining pin from the L-H shift rod.
CAUTION:
Do not reuse retaining pin.
5. Remove the 2-4 shift bracket.
6. Remove the retaining ring from the 2-4 shift fork using suitable
tool.
CAUTION:
Do not reuse retaining ring.
7. Remove the fork guide collar and 2-4 shift fork spring from the 2-
4 shift fork.
INSPECTION AFTER DISASSEMBLY
Shift Fork
• Measure the clearance between the shift fork and sleeve. If it is out
of specification, replace it with a new one.
Shift Rod and Fork Components
PDIA0122E
PDIA0125E
WDIA0226E
Standard value
2-4
: Less than 0.46 mm (0.018 in)
L-H
: Less than 0.46 mm (0.018 in)
PDIA0134E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст