Nissan Xterra. Manual — part 490
PRECAUTIONS
LU-3
< PRECAUTION >
[VQ40DE]
C
D
E
F
G
H
I
J
K
L
M
A
LU
N
P
O
1. Remove the old liquid gasket adhering to the gasket application
surface and the mating surface using suitable tool.
• Remove the liquid gasket completely from the groove of the
liquid gasket application surface, bolts, and bolt holes.
2. Thoroughly clean the mating surfaces and remove adhering
moisture, grease and foreign material.
3. Attach the liquid gasket tube to the suitable tool.
Use Genuine RTV Silicone Sealant or equivalent. Refer to
XX-XX, "*****"
.
4. Apply the liquid gasket without breaks to the specified location
with the specified dimensions.
• If there is a groove for the liquid gasket application, apply the
liquid gasket to the groove.
• Normally apply the liquid gasket on the inside edge of the bolt
holes. Also apply to the outside edge of the bolt holes when
specified in the procedure.
• Within five minutes of liquid gasket application, install the mat-
ing component.
• If the liquid gasket protrudes, wipe it off immediately.
• Do not retighten after the installation.
• Wait 30 minutes or more after installation before refilling the
engine with oil or coolant.
CAUTION:
If there are more specific instructions in the procedures contained in this manual concerning liq-
uid gasket application, observe them.
PBIC0003E
EMA0622D
SEM159F
LU-4
< PREPARATION >
[VQ40DE]
PREPARATION
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000009484414
The actual shape of tools may differ from those illustrated here.
Commercial Service Tool
INFOID:0000000009484415
Tool number
(TechMate No.)
Tool name
Description
ST25051001
(J-25695-1)
Oil pressure gauge
Measuring oil pressure
Maximum measuring range:
2,452 kPa (25 kg/cm
2
, 356 psi)
ST25052000
(J-25695-2)
Hose
Adapting oil pressure gauge to cylinder block
KV10111100
(J-37228)
Seal cutter
Removing steel oil pan and rear timing chain
case
KV10115801
(J-38956)
Oil filter wrench
Removing and installing oil filter
a: 64.3 mm (2.531 in)
S-NT050
S-NT559
NT046
S-NT375
PREPARATION
LU-5
< PREPARATION >
[VQ40DE]
C
D
E
F
G
H
I
J
K
L
M
A
LU
N
P
O
Tool name
Description
Power tool
Loosening nuts, screws and bolts
Deep socket
Removing and installing oil pressure switch
a: 24 mm (0.94 in)
Tube presser
Pressing the tube of liquid gasket
PIIB1407E
PBIC2072E
S-NT052
LU-6
< SYSTEM DESCRIPTION >
[VQ40DE]
LUBRICATION SYSTEM
SYSTEM DESCRIPTION
LUBRICATION SYSTEM
Lubrication Circuit
INFOID:0000000009484416
System Chart
INFOID:0000000009484417
PBIC2821E
PBIC2822E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст