Nissan Teana J32. Manual — part 756
INT-44
< ON-VEHICLE REPAIR >
REAR PARCEL SHELF FINISHER
5.
From the trunk room, disconnect left side speaker harness connector located behind sunshade control
unit (1) and the right side rear tweeter harness connector (LH/RH) as shown in the figure below.
6.
Hold from both sides the rear parcel shelf (1), pull it upward to
disengage the clips and then disconnect high-mounted stop
lamp harness connector (A) located on the left side only.
7.
Pull rear parcel shelf finisher to remove it.
8.
Remove the following parts after removing the rear parcel shelf.
• Rear tweeter. Refer to
AV-654, "Removal and Installation"
• High-mounted stop lamp. Refer to
EXL-193, "Removal and Installation"
.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Check that clips are securely fitted in panel holes on body when installing, and then press them in.
JMJIA1781ZZ
JMJIA1782ZZ
REAR SUNSHADE
INT-45
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
REAR SUNSHADE
Exploded View
INFOID:0000000003826196
Removal and Installation
INFOID:0000000003826197
REMOVAL
1.
Remove the rear parcel shelf finisher. Refer to
INT-43, "Removal and Installation"
.
2.
Remove the rear sunshade (1) fixing bolts (LH/RH).
1.
Rear sunshade
2.
Child anchor cover
3.
Rear parcel shelf finisher
: Clip
JMJIA1802ZZ
: Bolt
JMJIA1783ZZ
INT-46
< ON-VEHICLE REPAIR >
REAR SUNSHADE
3.
From the trunk room, disconnect the rear sunshade harness
connector (A) located between the left speaker (1) and the
speaker amp. (2).
4.
Remove the rear sunshade assembly.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Check that clips are securely fitted in panel holes on body when installing, and then press them in.
: Harness connector
JMJIA1784ZZ
FLOOR TRIM
INT-47
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
FLOOR TRIM
Exploded View
INFOID:0000000003819226
Removal and Installation
INFOID:0000000003819227
REMOVAL
1.
Remove front seat assembly (LH/RH). Refer to
SE-92, "Removal and Installation"
.
2.
Remove rear seat cushion. Refer to
SE-99, "Removal and Installation"
.
3.
Disengage clip of floor hook (1) with remover tool (A).
4.
Remove front seat belt per-tensioner anchor bolt (LH/RH). Refer to
.
5.
Remove center console assembly. Refer to
IP-22, "Removal and Installation"
.
1.
Trim clip
2.
Floor trim
3.
Front floor spacer (RH)
4.
Front floor spacer (LH)
5.
Floor hook
6.
Heel mat
7.
Fixing clip
: Vehicle front
JMJIA1803ZZ
: Clip
JMJIA0092GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст