Nissan Tiida C11. Manual — part 781
FRONT GRILLE
EXT-19
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
FRONT GRILLE
Removal and Installation
INFOID:0000000001568929
REMOVAL
1.
Open hood assembly.
2.
Remove the clips, then remove upper radiator cover.
3.
Remove the upper clips and release the lower pawls, then pull outward to remove the front grille.
INSTALLATION
Installation is in the reverse order of removal.
LIIA2564E
1.
Upper radiator cover
2.
Front grille
3.
Front bumper fascia
4.
Clip C205
Pawl
EXT-20
< ON-VEHICLE REPAIR >
COWL TOP
COWL TOP
Removal and Installation
INFOID:0000000001568930
REMOVAL
1.
Remove the front wiper arm RH/LH from vehicle. Refer to
WW-70, "Removal and Installation"
2.
Disconnect the washer tube.
3.
Remove the fender seal and fender cover RH/LH.
4.
Release the cowl top seal clips, then remove the cowl top seal.
LIIA2565E
1.
Fender cover
2.
Fender seal
3.
Washer tube
4.
Cowl top seal
5.
Cowl extension panel
6.
Dual lock fastener
7.
Double-faced adhesive tape
8.
Cowl top cover
9.
Clip C205
10. EPT sealer
11. Cowl extension clip
12. Cover
Clip CE103
⇐
Vehicle front
PIIB2555J
COWL TOP
EXT-21
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
5.
Release the cowl extension clip (1) by prying the center pawls
apart and pulling clip outward. Remove the remaining clips, then
remove the cowl top cover (2).
6.
Disconnect and remove the front wiper motor and linkage
assembly. Refer to
WW-73, "Removal and Installation"
CAUTION:
To avoid damage, make sure to cover the lower edge of
windshield with suitable protection material.
7.
Remove the cowl extension panel bolts, then remove the cowl extension panel.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
• For wiper arm RH/LH installation and adjustment, Refer to
WW-70, "Removal and Installation"
• Always replace EPT sealer and double-faced adhesive tape when installing cowl top cover.
LIIA2566E
PIIB6038E
EXT-22
< ON-VEHICLE REPAIR >
FENDER PROTECTOR
FENDER PROTECTOR
Component
INFOID:0000000001568931
Removal and Installation
INFOID:0000000001568932
FRONT FENDER PROTECTOR
Removal
1.
Remove the front fender protector bolts and clips.
2.
Remove the front fender protector.
Installation
Installation is in the reverse order of removal.
REAR FENDER PROTECTOR
Removal
1.
Remove the rear fender protector bolt (B) and clips (A) (C205).
2.
Remove the rear fender protector (1).
•
: Front
Installation
Installation is in the reverse order of removal.
1.
Front fender protector
2.
Clip C205
Clip C103
⇐
Vehicle front
AWKIA0101ZZ
AWKIA0100ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст