Nissan Sentra. Manual — part 911
TM-280
< REMOVAL AND INSTALLATION >
[CVT: RE0F11A]
CVT FLUID FILTER
3. Remove fluid filter cover (1) from transaxle by rotating leftward.
4. Remove CVT fluid filter (1) from transaxle.
INSTALLATION
Note the followings and install in the reverse order of removal.
CAUTION:
• Do not reuse fluid filter and fluid filter cover.
• Apply CVT fluid to fluid filter cover.
Inspection
INFOID:0000000010346192
INSPECTION AFTER INSTALLATION
• Start the engine and check visually that there is no leakage of engine coolant and CVT fluid.
• Check CVT fluid level.
JSDIA5048ZZ
JSDIA5049ZZ
ELECTRIC OIL PUMP
TM-281
< REMOVAL AND INSTALLATION >
[CVT: RE0F11A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
ELECTRIC OIL PUMP
Exploded View
INFOID:0000000010346193
Removal and Installation
INFOID:0000000010346194
REMOVAL
1. Remove neighboring parts of electric oil pump.
2. Remove electric oil pump sub harness.
3. Remove electric oil pump and motor assembly mounting bolts
(
).
4. Remove electric oil pump and motor assembly.
1.
Transaxle assembly
2.
Electric oil pump sub harness
3.
O-ring
4.
Electric oil pump and motor assembly
CVT fluid
JSDIA5053GB
JSDIA5051ZZ
TM-282
< REMOVAL AND INSTALLATION >
[CVT: RE0F11A]
ELECTRIC OIL PUMP
5. Remove O-ring (1).
INSTALLATION
Note the followings and install in the reverse order of removal.
CAUTION:
• Do not reuse O-ring.
• Apply CVT fluid to O-ring.
Inspection
INFOID:0000000010346195
INSPECTION BEFORE INSTALLATION
• Start the engine and check visually that there is no leakage of engine coolant and CVT fluid.
• Check CVT fluid level.
INSPECTION AFTER INSTALLATION
Perform bleeding of electric oil pump with CONSULT.
JSDIA5052ZZ
TRANSMISSION ASSEMBLY
TM-283
< UNIT REMOVAL AND INSTALLATION >
[CVT: RE0F11A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
UNIT REMOVAL AND INSTALLATION
TRANSMISSION ASSEMBLY
Exploded View
INFOID:0000000009759538
Removal and Installation
INFOID:0000000009759539
REMOVAL
WARNING:
Do not remove the radiator cap when the engine is hot. Serious burns could occur from high-pressure
coolant escaping from the radiator. Wrap a thick cloth around the cap. Slowly push down and turn it a
quarter turn to allow built-up pressure to escape. Carefully remove the cap by pushing it down and
turning it all the way.
CAUTION:
• Perform these steps after the coolant temperature has cooled sufficiently.
• Before replacing TCM and transaxle assembly as a set, perform "ADDITIONALSERVICE WHEN
REPLACING TCM AND TRANSAXLE ASSEMBLY". Refer to
.
Transaxle assembly
O-ring
CVT fluid charging pipe
CVT fluid charging pipe cap
Tightening must be done following the installation procedure. Refer to
TM-283, "Removal and Installation"
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Apply petroleum jelly
JSDIA3665GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст