Kia Carnival (2009+). Manual — part 282

13. Disconnect the pressure tube (A) and return (B) from the valve body housing.

Tightening torque Nm (kgf.m, lb-ft):
12 ~ 18 (1.2 ~ 1.8, 9 ~ 13)

14. Remove the power steering gear box (A) from the sub-frame by loosening the mounting bolts.

Tightening torque Nm (kgf.m, lb-ft):
60 ~ 80 (6.0 ~ 8.0, 43~58)

INSTALLATION

Be sure to connect between a tube and a hose as shown in the illustration.

1. Installation is the reverse of removal.

2. After installation, bleed the power steering system. (Refer to the air bleeding in ST group)

3. Adjust the wheel alignment. (Refer to SS group)

DISASSEMBLY

1. Remove the tie rod end (B) from the tie rod (A).

2. Remove the dust cover (B) from the ball joint (A).

3. Remove the bellows band (A).

4. Remove the bellows clip (A).

5. Pull the bellows out toward the tie rod.

Check for rust on the rack when the bellows are replaced.

6. Remove the feed tube(A) from the rack housing.

7. While moving the rack slowly, drain the fluid from the rack housing.

8. Unstake the tab washer (A) which fixes the tie rod (B) and rack (C) with a chisel.

9. Remove the tie rod (B) from the rack (A).

Remove the tie rod (B) from the rack (A), taking care not to twist the rack.

10. Remove the yoke plug locking nut (A).

11. Remove the yoke plug (B) with a 14mm socket (A).

12. Remove the lock nut (D), yoke plug (C), rack support spring (B) and rack support yoke (A) from the gear box.

13. When the end of the circlip comes out of the notchedhole of the housing rack cylinder, turn the rack stopper (A)

clockwise and remove the circlip.