Kia Carnival (2009+). Manual — part 317

2009 > G 2.7 DOHC >

REPLACEMENT

1. Remove the battery and air cleaner (see "Transaxle range switch replacement").

2. Remove the transaxle range switch connector.

3. Remove the control cable to transaxle range switch mounting nut.

4. Remove the input shaft speed sensor(A).

(1) Disconnect the input shaft speed sensor connector.

(2) Remove the bolt(B).

(3) Inspect the input shaft speed sensor bore.

5. Apply a light coat of automatic transaxle fluid to the O-ring seal before installation.

6. Install the input shaft speed sensor.

7. Install the control cable mounting bracket.

8. Connect the input shaft speed sensor connector.

9. Install the holder of the control cable.

10. Adjust the control cable to transaxle range switch and tighten the transaxle manual lever to the control cable

mounting nut. (see "Automatic transaxle shift control installation")

11. Installation is the reverse of removal.

Automatic Transaxle System

Automatic Transaxle Control System -

Output Speed Sensor

Automatic Transaxle System

2009 > G 2.7 DOHC >

DESCRIPTION

Output shaft speed sensor

- Type: Hall sensor
- Current consumption: 22mA (MAX.)
- Sensor body and sensor connector have been unified as one.

Hall type sensor: specification

Air gap (mm)

Output shaft speed sensor

0.85

Coil Resistance

Output shaft speed sensor

over 1M!

Peak-Peak Voltage

High

4.8~5.2V

Low

0.8V

Wave Form With High-scan

Hall Type Sensor: Structure & Interface