Kia Carnival (2009+). Manual — part 267

14. Pull out the joint(BJ) boot on the side of wheel into the transaxle direction.

Be careful not to damage the boot.

REASSEMBLY

1. Wrap tape around the drive shaft splines (UTJ side) to prevent damage to the boots.

2. Apply grease to the joint(BJ) boot on the side of wheel and install the boots.

3. Install the bands to both boots.

4. Using clamp, secure the boot bands.

Clearance (A) : 2.0 mm (0.079 in.) or less

5. To install the dynamic damper, keep the BJ shaft in a straight line and secure the dynamic damper with the

dynamic damper bands.

6. Install the UTJ boot bands and UTJ boot.

7. Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and snap ring

(B) on the driveshaft splines (C).

(B) on the driveshaft splines (C).

8. Add the specified grease to the joint(UTJ) boot as mush as wiped away at inspection.

9. Install the boots.

10. To control the air in the UTJ boot, keep the specified distance between the boot bands when they are tightened.

Standard value [A]

Items

Standard (A) mm(in)

LH

RH

2.9 Diesel M/T

505.4 (19.90)

466.8 (18.38)

2.9 Diesel A/T

507.5 (19.98)

466.9 (18.38)

3.8 Gasoline A/T

557.1 (21.93)

570.7 (22.47)

11. Install both sides of the boot bands by using SST (09495-39100).

Driveshaft and Axle

Front Axle Assembly - Front Hub/Axle

Driveshaft and Axle