Kia Carnival (2009+). Manual — part 269

Tightening torque Nm (Kgf.m, lb-ft):
90 ~ 120 (9.0 ~ 12.0, 65 ~ 87)

10. Using a plastic hammer, disconnect the driveshaft (A) from the front hub assembly (B).

11. Remove the brake disc (A) from the front hub assembly.

12. Remove the knuckle from the strut assembly by loosening the bolts (A).

Tightening torque Nm (kgf.m, lb-ft):
100 ~ 120 (10.0 ~12.0, 72 ~ 87)

INSTALLATION

1. Installation is reverse of the removal.

• The driveshaft lock nut should be replaced with new ones.
• After installation driveshaft lock nut, stake the lock nut using a chisel and hammer as shown in the

illustration below.

DISASSEMBLY

1. Separate the hub & bearing assembly (A) from the knuckle (B) by loosening the bolts.

Tightening torque Nm (kgf.m, lb-ft):
160 ~ 180 (16.0 ~ 18.0, 116 ~ 130)

INSPECTION

1. Check the hub for cracks and the splines for wear.

2. Check the brake disc for scoring and damage.

3. Check the knuckle for cracks.

REASSEMBLY

1. Reassembly is reverse of the disassembly.

2. Measure the wheel bearing starting toque.

20 kgf.cm or less

3. Measure the hub assembly axial play using a dial gauge.

0.008 mm or less

Driveshaft and Axle

Rear Axle Assembly - Rear Hub/Carrier

Driveshaft and Axle