Hummer H3. Manual — part 1448
BACKUP LAMP BULB REPLACEMENT
Fig. 158: Replacing Backup Lamp Bulb
Courtesy of GENERAL MOTORS CORP.
Backup Lamp Bulb Replacement
2
Bolts, High Mounted Stop Lamp (Qty: 2)
Tighten: 2 N.m (18 lb in)
3
Lamp Assembly - High Mounted Stop (LED) (Qty: 1)
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.
Preliminary Procedure:
Remove either the LR or RR tail lamp assembly. Refer to Tail Lamp Replacement.
1
Back Up Lamp Bulb Socket
Tip: Turn the lamp socket counter-clockwise a quarter turn to remove from
the tail lamp.
2
Back Up Lamp Bulb
Tip: Pull the bulb straight from the lamp socket.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
REAR LICENSE LAMP REPLACEMENT (BASE)
Fig. 159: License Lamp Replacement
Courtesy of GENERAL MOTORS CORP.
Rear License Lamp Replacement (Base)
REAR LICENSE LAMP REPLACEMENT (WITH BRM AND RHD)
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.
NOTE:
Refer to Fastener Notice .
1
Screws, License Plate Lamp (Qty: 2)
Tighten: 2 N.m (18 lb in)
2
Connector, License Plate Lamp Assembly (Qty: 1)
Tip: Pull electrical harness slightly rearward to disconnect from socket.
3
Lamp Assembly - Rear License Plate (Qty: 1)
Tip: Hold socket and rotate lens counterclockwise to remove from socket.
4
Bulb, Rear License Plate Lamp (Qty: 1)
Tip: Hold socket and pull bulb straight outward.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
Fig. 160: Replacing Rear License Lamp
Courtesy of GENERAL MOTORS CORP.
Rear License Lamp Replacement (with BRM and RHD)
TAIL LAMP REPLACEMENT
Callout
Component Name
1
Rear License Plate Lamp Assembly
Tip: Depress the very small lamp tabs inboard towards the outboard side of
the vehicle in order to release the lamps from the impact bar bumper cover.
2
License Plate Lamp Socket
Tip: Twist the lamp socket electrical connector counter-clockwise and
remove from the lens housing.
3
License Plate Lamp Bulb
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
Fig. 161: Tail Lamp Assembly Replacement
Courtesy of GENERAL MOTORS CORP.
Tail Lamp Replacement
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening
Specifications.Preliminary Procedure: Open the endgate in order to access the left rear
taillamp assembly screws.
NOTE:
Refer to Fastener Notice .
1
Screws, Tail Lamp Housing (Qty: 2)
Tip: Pull lamp housing outward in order to release the exterior side pin
retainers.
Tighten: 3 N.m (26 lb in)
2
Lamp Assembly, Tail
Tip: Disconnect the bulb sockets from the lamp housing by rotating
counterclockwise.
3
Connector, Tail Lamp Electrical
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст