Hummer H3. Manual — part 462
1. Tighten the new crankshaft balancer bolt while holding the back to 150 N.m (110 lb
ft).
2. Use J 45059 to tighten the crankshaft balancer bolt an additional 180 degrees. See
Special Tools.
FUEL RAIL AND INJECTORS INSTALLATION
Fig. 664: Identifying Fuel Injector Rail Bolts
Courtesy of GENERAL MOTORS CORP.
1. Lubricate the lower injector O-rings with mineral oil GM P/N 9981704.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
2. Install the fuel injector rail.
3. Install the fuel injector rail bolts.
Tighten: Tighten the fuel injector rail bolts to 10 N.m (89 lb in).
INTAKE MANIFOLD INSTALLATION
Fig. 665: Identifying Intake Manifold And Bolts
Courtesy of GENERAL MOTORS CORP.
1. Install a new intake manifold gasket.
NOTE:
Refer to FASTENER NOTICE .
NOTE:
Refer to FASTENER NOTICE .
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
2. Install the intake manifold and bolts.
Tighten: Tighten the intake manifold bolts from the inside out to 10 N.m (89 lb in).
Fig. 666: Identifying Throttle Control Module Bolts
Courtesy of GENERAL MOTORS CORP.
3. Install a new throttle control module gasket.
4. Install the throttle control module.
5. Add threadlock GM P/N 12346004 (Canadian P/N 10953480) to the throttle control
module bolt threads.
6. Install the throttle control module bolts.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Tighten: Tighten the throttle control module bolts to 10 N.m (89 lb in).
ENGINE COOLANT THERMOSTAT HOUSING INSTALLATION
Fig. 667: View Of Thermostat Housing
Courtesy of GENERAL MOTORS CORP.
1. Install the thermostat housing.
2. Install the thermostat housing bolts.
NOTE:
Refer to FASTENER NOTICE .
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст