Hummer H3. Manual — part 461
Fig. 660: View Of Oil Pan
Courtesy of GENERAL MOTORS CORP.
3. Install the oil pan.
4. Install the oil pan bolts.
IMPORTANT: The oil pan must be installed within 10 minutes from when
the sealer was applied.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 661: Aligning Oil Pan
Courtesy of GENERAL MOTORS CORP.
5. Check the oil pan alignment. Use a straight edge on the back of the block and oil pan
(transmission mounting surface).
6. Tighten the oil pan bolts.
Tighten:
Tighten the (side) oil pan bolts to 25 N.m (18 lb ft).
IMPORTANT: When installing the oil pan, it could be shifted front or back a
little which could cause a transmission alignment problem.
The back of the oil pan needs to be flush with the block.
NOTE:
Refer to FASTENER NOTICE .
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Tighten the (end) oil pan bolts to 10 N.m (89 lb in).
CRANKSHAFT BALANCER INSTALLATION
Tools Required
J 45059 Angle Meter. See Special Tools.
J 41478 Crankshaft Balancer Installer. See Special Tools.
Installation Procedure
Fig. 662: Installing Crankshaft Balancer Using The J 41478
Courtesy of GENERAL MOTORS CORP.
1. Install the friction washer on the back side of the crankshaft balancer.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
2. Install the crankshaft balancer using J 41478 . See Special Tools.
3. Remove J 41478 . See Special Tools.
4. Hold the flywheel or back of the crankshaft. The crankshaft balancer does not have a
keyway so the crankshaft could turn when tightening, causing an improper torque.
Fig. 663: View Of Crankshaft Balancer Bolt
Courtesy of GENERAL MOTORS CORP.
5. Install the crankshaft balancer washer and new bolt.
Tighten:
NOTE:
Refer to FASTENER NOTICE .
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст