Hummer H3. Manual — part 1728

Fig. 80: Applying Pinch-Weld Primer
Courtesy of GENERAL MOTORS CORP.

7. Shake the pinch-weld primer black #3 for at least 1 minute.

8. Use a new dauber in order to apply the primer to the surface of the pinch-weld flange (1).

9. Allow the pinch-weld primer to dry for approximately 10 minutes.

CAUTION: Refer to Failure to Prep Primer Caution .

IMPORTANT: Do not apply the black #3 primer to the existing bead (1) of

the urethane adhesive on the pinch-weld flange. Apply the
primer only to nicks, scratches or the primed surfaces.

2007 Hummer H3

2007 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - H3

Fig. 81: Installing Rear Window
Courtesy of GENERAL MOTORS CORP.

10. With the aid of an assistant, dry fit the window (2) to the opening in order to determine the

correct position.

11. Ensure that the locator pins (1) are positioned into the locator slots on the upper pinch-weld

flange.

2007 Hummer H3

2007 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - H3

Fig. 82: Aligning Tape Lines On Window To Body
Courtesy of GENERAL MOTORS CORP.

12. Use masking tape (1) to mark the locations of the window in the opening.

13. Cut the masking in the center and remove the window from the opening.

2007 Hummer H3

2007 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - H3

Fig. 83: Applying Glass Prep
Courtesy of GENERAL MOTORS CORP.

14. Use a new dauber in order to apply glass prep clear #1 to the area approximately 18 mm

(0.71 in) around the entire perimeter of the window inner surface.

Immediately wipe the glass primed area using a clean, lint-free cloth.

IMPORTANT: Use care when applying glass prep clear #1 on the window.

This primer dries almost instantly and may stain the viewing
area of the window if not applied evenly.

2007 Hummer H3

2007 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - H3