Hummer H3. Manual — part 953
J 21128 Axle Pinion Oil Seal Installer. See Special Tools.
Removal Procedure
Fig. 46: Measuring Pinion Rotation Torque - Front Axle
Courtesy of GENERAL MOTORS CORP.
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the engine protection shield (EPS). Refer to Engine Shield Replacement .
3. Drain the drive axle. Refer to Front Axle Lubricant Replacement.
4. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .
2007 Hummer H3
2007 Driveline/Axle Front Drive Axle - H3
5. Remove the brake calipers. Refer to Front Brake Caliper Replacement .
6. Measure the torque required in order to rotate the pinion. Using an inch-pound torque
wrench, record the torque value for reassembly. This will give the combined preload for the
following components:
The pinion bearings
The pinion seal
The carrier bearings
The axle bearings
The axle seals
Fig. 47: View Of Pinion Shaft & Pinion Yoke Alignment Marks
Courtesy of GENERAL MOTORS CORP.
7. Scribe an alignment line between the pinion shaft and the pinion yoke.
2007 Hummer H3
2007 Driveline/Axle Front Drive Axle - H3
Fig. 48: Holding Pinion Yoke With Special Tool
Courtesy of GENERAL MOTORS CORP.
8. Install the J 8614-01 (1) onto the pinion, as shown. See Special Tools.
9. Remove the pinion nut while holding the J 8614-01 (1). See Special Tools.
10. Install the J 8614-2 (2) and the J 8614-3 (3) into the J 8614-01 (1), as shown. See Special
Tools.
11. Remove the pinon yoke by turning the J 8614-3 (3) clockwise, while holding the J 8614-01
(1). See Special Tools.
12. Remove the oil seal using a suitable seal removal tool.
IMPORTANT: Carefully remove the seal from the bore. Do not distort or
scratch the aluminum case.
2007 Hummer H3
2007 Driveline/Axle Front Drive Axle - H3
Fig. 49: View Of Dust Deflector
Courtesy of GENERAL MOTORS CORP.
13. Remove the dust deflector from the pinion yoke using a soft-faced hammer.
Installation Procedure
2007 Hummer H3
2007 Driveline/Axle Front Drive Axle - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст