Hummer H3. Manual — part 952
Fig. 42: View Of Engine Protection Shield
Courtesy of GENERAL MOTORS CORP.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the engine protection shield (EPS), if equipped. Refer to Engine Shield
Replacement .
3. Drain the front differential assembly.
2007 Hummer H3
2007 Driveline/Axle Front Drive Axle - H3
Fig. 43: Identifying Differential Cover, Gasket & Bolts
Courtesy of GENERAL MOTORS CORP.
4. Remove the differential cover bolts.
5. Remove the differential cover and gasket.
Installation Procedure
IMPORTANT: The front differential housing cover gasket is reusable. DO
NOT replace unless gasket is damaged.
2007 Hummer H3
2007 Driveline/Axle Front Drive Axle - H3
Fig. 44: Identifying Differential Cover, Gasket & Bolts
Courtesy of GENERAL MOTORS CORP.
1. Install the differential cover and gasket.
2. Install the differential cover bolts.
Tighten: Tighten the differential cover bolts to 30 N.m (22 lb ft).
3. Fill the front differential with fluid. Refer to Front Axle Lubricant Replacement.
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 Driveline/Axle Front Drive Axle - H3
Fig. 45: View Of Engine Protection Shield
Courtesy of GENERAL MOTORS CORP.
4. Install the EPS, if equipped. Refer to Engine Shield Replacement .
5. Lower the vehicle.
FRONT DIFFERENTIAL DRIVE PINION FLANGE/YOKE, SEAL AND DUST DEFLECTOR
REPLACEMENT
Tools Required
J 8614-01 Flange and Pulley Holding Tool. See Special Tools.
2007 Hummer H3
2007 Driveline/Axle Front Drive Axle - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст