Hummer H3. Manual — part 905
Fig. 9: Rear Door Replacement
Courtesy of GENERAL MOTORS CORP.
Rear Door Replacement
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
NOTE:
Refer to Fastener Notice .
1
Bolt, Rear Side Door Check Link
Tighten: 25 N.m (18 lb ft)
2
Bolt, Rear Side Door Upper Hinge (Qty: 2)
Tip:
1. Support door before removing hinge bolts.
2. Disconnect door electrical connector.
Tighten: 27 N.m (20 lb ft)
3
Bolt, Rear Side Door Lower Hinge (Qty: 2)
Tighten: 27 N.m (20 lb ft)
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bolted Exterior Body Panels and Closures - H3
ENDGATE REPLACEMENT
Fig. 10: Endgate Replacement
Courtesy of GENERAL MOTORS CORP.
Endgate Replacement
4
Door Assembly, Rear Side
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.
Preliminary Procedures
1. Remove the lower endgate trim panel. Refer to Endgate Trim Panel Replacement .
2. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement .
3. Remove the endgate strut. Refer to Endgate Strut Replacement.
NOTE:
Refer to Fastener Notice .
1
Bolts, Hinge (Qty: 4)
Tighten: 50 N.m (37 lb ft)
2
Endgate, Endgate Assembly
Tip:
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bolted Exterior Body Panels and Closures - H3
FRONT FENDER REPLACEMENT
Fig. 11: Replacing Front Fender
Courtesy of GENERAL MOTORS CORP.
Front Fender Replacement
Disconnect washer hose.
Disconnect electrical connector.
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.
Preliminary Procedures
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bolted Exterior Body Panels and Closures - H3
HOOD LATCH RELEASE HANDLE REPLACEMENT
1. Remove the front wheelhouse opening flare. Refer to Front Wheel Opening Flare
Replacement (Base) or Front Wheel Opening Flare Replacement (with BRM
and RHD) .
2. Remove the front wheelhouse panel. Refer to Wheelhouse Panel Replacement
(Front) or Wheelhouse Panel Replacement (Rear) .
3. Remove the rocker panel molding. Refer to Rocker Panel Molding Replacement .
4. Remove air inlet grille panel. Refer to Non-Functional Air Inlet Grille Panel
Replacement .
1
Bolts, Front Fender (Qty: 2)
Tighten: 10 N.m (89 lb in)
2
Bolt, Front Fender (Qty: 2)
Tighten: 10 N.m (89 lb in)
3
Bolt, Front Fender (Qty: 3)
Tighten: 10 N.m (89 lb in)
4
Fender, Front Fender
Tip: On right side fender, remove the antenna mast. Refer to Fixed
Antenna Mast Replacement .
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bolted Exterior Body Panels and Closures - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст