Hummer H3. Manual — part 904
Fig. 6: Identifying Hood Release Handle
Courtesy of GENERAL MOTORS CORP.
4. Install the release handle (3) to the knee bolster.
5. Install the screws that retain the release handle to the knee bolster.
Tighten: Tighten the bolts to 2 N.m (18 lb in).
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bolted Exterior Body Panels and Closures - H3
Fig. 7: View Of Hood Latch Cable
Courtesy of GENERAL MOTORS CORP.
6. Route the cable as previously noted.
7. Attach the cable to the retainers on the inner fender.
8. Install the cable to the hood latch assembly.
9. Install the hood latch. Refer to Hood Latch Replacement.
10. Install the grille. Refer to Grille Replacement .
DOOR HARDWARE LUBRICATION
The mechanical components of the door assembly receive lubrication during the assembly. If any
door hardware mechanism needs additional lubrication, use multi-purpose lubricant GM P/N
12346241 or Canadian P/N 10953474 or equivalent.
FRONT SIDE DOOR REPLACEMENT
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bolted Exterior Body Panels and Closures - H3
Fig. 8: Front Side Door Replacement
Courtesy of GENERAL MOTORS CORP.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bolted Exterior Body Panels and Closures - H3
Front Side Door Replacement
REAR DOOR REPLACEMENT
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
NOTE:
Refer to Fastener Notice .
1
Bolt, Front Side Door Upper Hinge (Qty: 2)
Tip:
1. Support door before removing hinge bolts.
2. Disconnect door electrical connector.
Tighten: 27 N.m (20 lb ft)
2
Bolt, Front Side Door Check Link
Tighten: 25 N.m (18 lb ft)
3
Bolt, Front Side Door Lower Hinge (Qty: 2)
Tighten: 27 N.m (20 lb ft)
4
Door Assembly, Front Side
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bolted Exterior Body Panels and Closures - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст