Hummer H2. Manual — part 929
Fig. 89: Installing J 45754-4 Into Pinion Bearing Bore Behind Outer Pinion Bearing Cup
Courtesy of GENERAL MOTORS CORP.
45. Install the J 45754-4 (3) into the pinion bearing bore behind the outer pinion bearing cup.
Slowly turn the forcing screw (1) until the J 45754-4 is evenly seated behind the outer pinion bearing cup
bore and the J 45754-2 (2) is evenly seated over the outer pinion bearing cup bore.
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
46. Remove the outer pinion bearing cup by turning the forcing screw clockwise.
Fig. 90: Installing J 45755-3, J 45755-4, Forcing Screw, Bearing & Washers Over Differential
Carrier Assembly
Courtesy of GENERAL MOTORS CORP.
47. Install the J 45755-3 (2), J 45755-4 (3), and the forcing screw, bearing and the washers (1) over the
differential carrier assembly bushing as shown.
48. Remove the differential carrier assembly bushing using the J 45755 . See Special Tools and
Equipment .
DIFFERENTIAL CASE ASSEMBLY DISASSEMBLE
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Tools Required
z
J 22888-D Side Bearing Remover Kit. See Special Tools and Equipment .
z
J 36597 Side Bearing Puller Pilot - 9.25 in Axle
1. Remove the differential side bearing by performing the following steps:
1. Place the differential case in a vise.
Fig. 91: Removing Differential Side Bearings
Courtesy of GENERAL MOTORS CORP.
2. Install the J 22888-20A (2) and the J 36597 (1) as shown. See Special Tools and Equipment .
3. Remove the differential side bearings using the J 22888-20A .
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
2. Remove the differential assembly from the vise.
Fig. 92: Identifying Ring Gear Bolts
Courtesy of GENERAL MOTORS CORP.
IMPORTANT: The ring gear bolts have left-hand threads.
2004 Hummer H2
2004 DRIVELINE/AXLE Front Drive Axle - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст