Toyota Tundra. Manual — part 1467
Fig. 358: Identifying VVT Sensor Replacement Components With Torque Specifications (1 Of 3)
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 359: Identifying VVT Sensor Replacement Components With Torque Specifications (2 Of 3)
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 360: Identifying VVT Sensor Replacement Components With Torque Specifications (3 Of 3)
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
Some systems need to be initialized after the cable is reconnected.
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
2. REMOVE INTAKE MANIFOLD ASSEMBLY
a. Remove the intake manifold. (See REMOVAL ).
3. REMOVE VVT SENSOR
a. Disconnect the 2 sensor connectors.
b. Remove the 2 bolts and 2 sensors.
Fig. 361: Locating Sensor Connectors With Bolts
INSPECTION
1. INSPECT VVT SENSOR
a. Measure the resistance according to the value(s) in the table below.
Standard resistance
STANDARD RESISTANCE SPECIFICATION
(See INITIALIZATION ).
After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
memory and settings. As a result, after turning the ignition switch
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.
Tester Connection Condition Specified Condition
1 - 2
Cold
835 to 1400 ohms
1 - 2
Hot
1060 to 1645 ohms
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст