Toyota Tundra. Manual — part 499
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
FRONT NO. 2 SPEAKER LH TESTER CONNECTION SPECIFIED CONDITION
Fig. 115: Identifying K12 Speaker Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPLACE FRONT NO. 2 SPEAKER LH (See REMOVAL )
OK: Go to Next Step
11. INSPECT FRONT NO. 2 SPEAKER RH
a. Disconnect the K10 speaker connector.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
FRONT NO. 2 SPEAKER RH TESTER CONNECTION SPECIFIED CONDITION
Tester Connection Condition Specified Condition
3(TWL+)-4(TWL-) Always
1.3 to 2.3 ohms
1(+)-3(TWL+)
Always
Below 1 ohms
2(-)-4(TWL-)
Tester Connection Condition Specified Condition
3(TWR+)-4(TWR-) Always
1.3 to 2.3 ohms
1(+)-3(TWR+)
Always
Below 1 ohms
2(-)-4(TWR-)
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
Fig. 116: Identifying K10 Speaker Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPLACE FRONT NO. 2 SPEAKER RH (See REMOVAL )
OK: Go to Next Step
12. INSPECT REAR NO. 1 SPEAKER LH
a. Disconnect the O7 speaker connector.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
REAR NO. 1 SPEAKER LH TESTER CONNECTION SPECIFIED CONDITION
Fig. 117: Identifying O7 Speaker Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPLACE REAR NO. 1 SPEAKER LH (See REMOVAL )
OK: REPLACE REAR NO. 1 SPEAKER RH (See REMOVAL )
Tester Connection Condition Specified Condition
1-2
Always
1.5 to 2.1 ohms
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
NOISE OCCURS
INSPECTION PROCEDURE
1. CHECK SPEAKER INSTALLATION
a. Check that each speaker is securely installed.
OK: Each speaker is securely installed.
NG: INSTALL SPEAKER PROPERLY
OK: Go to Next Step
2. IDENTIFY NOISE SOURCE
a. Check the noise condition.
HINT:
The radio has a noise prevention function to reduce noise when listening to the radio. If a loud
noise occurs, check whether the ground at the antenna mounting base and the noise prevention unit
are installed and wired correctly.
NOISE CONDITION CHART
HINT:
In the chart's left column, find the situation that matches the customer's vehicle. Then, in the
Condition in Which Noise Occurs
Noise Type
Depressing accelerator pedal increases noise, and stopping engine
stops noise immediately
Generator noise
When A/C or heater is operating
Blower motor noise
When rapidly accelerating on unpaved road
When ignition switch is turned ON
Fuel pump noise
When horn switch is pressed and released
When horn switch is pressed and held down
Horn noise
Running engine causes soft noise, and stopping engine stops noise
immediately
Ignition noise
Noise occurs synchronously with turn signal flash
Flasher noise
Noise occurs during window washer operation
Washer noise
Running engine causes noise, but stopping engine does not stop
noise
Engine coolant temperature
sensor noise
When wiper is operating
Wiper noise
When brake pedal is depressed
Stop light switch noise
Other
Static electricity on vehicle
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
right column, find the part that is causing the noise. Check the noise filter on the part.
To save time and avoid a misdiagnosis, first make sure that the noise is not originating from
outside the vehicle.
Troubleshoot noise problems in order of loudness, starting with the loudest noise.
Setting the radio to a frequency that receives no signal may make recognition of the noise
problem easier.
OK: The noise source can be determined.
NG: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE
OK: REPAIR OR REPLACE NOISE SOURCE
NO SOUND CAN BE HEARD FROM SPEAKERS
INSPECTION PROCEDURE
1. CHECK SOUND SETTING
a. Enter the sound adjustment screen by pressing the "SOUND" switch on the AUDIO display.
b. Set volume, fader, and balance to the initial values and check that sound is normal.
OK: Sound returns to normal.
HINT:
Sound quality adjustment items vary depending on the type of the amplifier.
Fig. 118: Identifying Audio Setting
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE
OK: END
CD CANNOT BE EJECTED
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст