Toyota Tundra. Manual — part 320
OK: When cruise control main switch operation is performed, the result will be same as
above.
Result
RESULT REFERENCE
B: REPLACE ECM (See REMOVAL (1GR-FE))
C: REPLACE ECM (See REMOVAL (2UZ-FE))
D: REPLACE ECM (See REMOVAL (3UR-FE))
E: REPLACE ECM (See REMOVAL (3UR-FBE))
A: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE
TC AND CG TERMINAL CIRCUIT
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the system to enter self-diagnostic mode. If a malfunction
is present, DTCs will be output.
HINT:
When a particular warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or
an internal ground short in the relevant ECU is suspected.
WIRING DIAGRAM
Result
Proceed to
OK
A
NG (for 1GR-FE)
B
NG (for 2UZ-FE)
C
NG (for 3UR-FE)
D
NG (for 3UR-FBE)
E
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Cruise Control - Tundra
Fig. 22: TC And CG Terminal Circuit - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)
a. Disconnect the A24 ECM connector.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
DLC3 - ECM AND BODY GROUND
Tester Connection
Condition
Specified Condition
J17-13 (TC) - A24-16 (TC)
Always
Below 1 ohms
L17-4 (CG) - Body ground
J17-13 (TC) - Body ground
Always
10 kohms or higher
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Cruise Control - Tundra
Fig. 23: Checking Harness And Connector (DLC3 - ECM And Body Ground)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE PROBLEM SYMPTOMS TABLE
CRUISE CONTROL MAIN SWITCH
COMPONENTS
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Cruise Control - Tundra
Fig. 24: Identifying Cruise Control Main Switch Components With Torque Specification
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the
negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Cruise Control - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст