Toyota Tundra. Manual — part 436
REFERENCE
If the result is not as specified, replace the rheostat.
INSTALLATION
1. INSTALL LIGHT CONTROL RHEOSTAT
a. Attach the 2 claws to install the rheostat.
Fig. 78: Identifying Rheostat And Claws
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (see INSTALLATION )
DRIVE MONITOR SWITCH
COMPONENTS
Tester Connection Switch Condition Specified Condition
3 (RV) - 1 (E)
Downside --> Upside
See illustration
5 (TC) - 1 (E)
7 (T) - 1 (E)
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
Fig. 79: Identifying Drive Monitor Switch Components
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (see REMOVAL )
2. REMOVE DRIVE MONITOR SWITCH
a. Detach the 2 claws and remove the monitor switch.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
Fig. 80: Identifying Monitor Switch And Claws
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION
1. INSPECT DRIVE MONITOR SWITCH
a. Measure the resistance according to the value(s) in the table below.
Fig. 81: Identifying Drive Monitor Switch Connector Terminal
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Standard resistance
DRIVE MONITOR SWITCH RESISTANCE REFERENCE
Tester Connection
Switch Condition
Specified Condition
2 (MODE) - 5 (E)
Info switch off
10 kohms or higher
Info switch on
Below 1 ohms
3 (REST) - 5 (E)
Select reset switch off 10 kohms or higher
Select reset switch on
Below 1 ohms
4 (SET) - 5 (E)
Setup us/m switch off 10 kohms or higher
Setup us/m switch on
Below 1 ohms
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
If the result is not as specified, replace the monitor switch.
b. Inspect the switch illumination.
1. Connect the battery's positive (+) lead to terminal 1 (ILL+) and the negative (-) lead to
terminal 6 (ILL-).
2. Check that the light comes on.
OK: LED comes on.
If the result is not as specified, replace the monitor switch.
INSTALLATION
1. INSTALL DRIVE MONITOR SWITCH
a. Attach the 2 claws to install the monitor switch.
Fig. 82: Identifying Monitor Switch And Claws
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (see INSTALLATION )
7 (IG) - 8 (SK)
Sonar switch off
10 kohms or higher
Sonar switch on
Below 1 ohms
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст