Toyota Tundra. Manual — part 434
Fig. 68: Identifying Wire Harness
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c. Attach the 12 clips to install the finish panel.
Fig. 69: Identifying Connectors And Clamps
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ACCESSORY METER
COMPONENTS
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
Fig. 70: Identifying Accessory Meter Components
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
ON-VEHICLE INSPECTION
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
Fig. 71: Identifying Accessory Meter Assembly
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
1. INSPECT ACCESSORY METER ASSEMBLY
a. Measure the resistance according to the value(s) in the table below.
Standard resistance
ACCESSORY METER ASSEMBLY RESISTANCE REFERENCE
b. Measure the voltage according to the value(s) in the table below.
Standard voltage
ACCESSORY METER ASSEMBLY VOLTAGE SPECIFICATIONS
REMOVAL
1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
a. for Column Shift Type:
Remove the instrument panel (see REMOVAL ).
b. for Floor Shift Type:
Remove the instrument panel (see REMOVAL ).
Tester Connection Condition Specified Condition
12 (E)-Body ground Always
Below 1 ohms
Tester Connection
Condition
Specified Condition
22 (ACC) - Body ground
Ignition switch OFF
Below 1 V
Ignition switch ACC
10 to 14 V
24 (+B) - Body ground
Always
10 to 14 V
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
2. REMOVE NO. 1 HEATER TO REGISTER DUCT WITH NO. 2 HEATER TO REGISTER DUCT
(See DISASSEMBLY )
3. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT (See DISASSEMBLY )
4. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY (See DISASSEMBLY )
5. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT (See DISASSEMBLY )
6. REMOVE DEFROSTER NOZZLE ASSEMBLY (See DISASSEMBLY )
7. REMOVE ACCESSORY METER ASSEMBLY
a. Disconnect the accessory meter connector.
Fig. 72: Identifying Accessory Meter Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Remove the 3 screws and accessory meter.
INSTALLATION
1. INSTALL ACCESSORY METER ASSEMBLY
a. Install the accessory meter with the 3 screws.
Fig. 73: Identifying Accessory Meter With Screws
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Connect the accessory meter connector.
2. INSTALL DEFROSTER NOZZLE ASSEMBLY (See REASSEMBLY )
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст