Toyota Tundra. Manual — part 522
If the power source circuit is operating normally, proceed to the next step.
3. CHECK NAVIGATION RECEIVER
a. Disconnect the K18 receiver connector.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
NAVIGATION RECEIVER TESTER CONNECTION SPECIFIED CONDITION
Fig. 214: Identifying K18 Receiver Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Result
NAVIGATION RECEIVER RESULT CHART
B: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Column Shift Type) )
C: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Floor Shift Type) )
A: Go to Next Step
4. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMPONENT SHOWN
BY SUB-CODE)
HINT:
POWER SOURCE CIRCUIT
Tester Connection Condition Specified Condition
E5(ATX+)-15(ATX-) Always
60 to 80 ohms
Result
Proceed to
OK
A
NG (for Column Shift Type)
B
NG (for Floor Shift Type)
C
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
Start the check from the circuit that is near the component shown by the sub-code first.
For details of the connectors, refer to "TERMINALS OF ECU" .
a. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the
navigation receiver and the component shown by the sub-code.
1. Disconnect all connectors between the navigation receiver and the component shown by sub-
code.
2. Check for an open or short in the AVC-LAN circuit between the navigation receiver and the
component shown by the sub-code.
OK: There is no open or short circuit.
Fig. 215: AVC-LAN Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: Go to Next Step
5. REPLACE COMPONENT SHOWN BY SUB-CODE
a. Replace the component shown by the sub-code with a normal one and check if the same problem
occurs again.
OK: Same problem does not occur.
Result
COMPONENT SHOWN BY SUB-CODE RESULT CHART
B: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Column Shift Type) )
Result
Proceed to
OK
A
NG (for Column Shift Type)
B
NG (for Floor Shift Type)
C
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
C: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Floor Shift Type) )
A: END
NAVIGATION SYSTEM (FOR CREWMAX)
PARTS LOCATION
Fig. 216: Identifying Navigation System Parts Location - For Crewmax (1 Of 3)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
Fig. 217: Identifying Navigation System Parts Location - For Crewmax (2 Of 3)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст