Toyota Tundra. Manual — part 2481
WIRING DIAGRAM
Fig. 32: Identifying Front Fog Light - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. PERFORM ACTIVE TEST BY TECHSTREAM (FRONT FOG LIGHT)
a. Operate the Techstream according to the steps on the display and select "Active Test".
Techstream
Main Body
MAIN BODY - TECHSTREAM ACTIVE TEST CHART
OK: Front fog light turns on / turns off.
NG: Go to step 2
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE
2. INSPECT FUSE (FOG)
a. Remove the FOG fuse from the engine room junction block.
b. Measure the resistance according to the value(s) in the table below.
Tester Display
Test Part
Control Range Diagnostic Note
Front Fog Light Front fog light
ON or OFF
-
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Lighting - Tundra
Standard resistance
FUSE (FOG)
NG: REPLACE FUSE
OK: Go to next step
3. CHECK HARNESS AND CONNECTOR (FRONT FOG LIGHT BULB - BATTERY)
a. for LH:
1. Disconnect the A30 front fog light connector.
Fig. 33: Identifying Front Fog Light Connector Terminals - LH
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. Measure the voltage according to the value(s) in the table below.
Standard voltage
FRONT FOG LIGHT BULB - BATTERY LH
b. for RH:
Tester Connection Condition Specified Condition
FOG fuse
Always
Below 1 ohms
Tester Connection
Switch Condition
Specified
Condition
A30-2 - Body
ground
Light control switch TAIL, front fog light switch
ON
11 to 14 V
Light control switch TAIL, front fog light switch
OFF
Below 1 V
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Lighting - Tundra
1. Disconnect the A31 front fog light connector.
Fig. 34: Identifying Front Fog Light Connector Terminals - RH
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. Measure the voltage according to the value(s) in the table below.
Standard voltage
FRONT FOG LIGHT BULB - BATTERY RH
NG: Go to step 4
OK: REPAIR OR REPLACE HARNESS OR CONNECTOR (FRONT FOG LIGHT BULB -
BODY GROUND)
4. INSPECT FOG LIGHT RELAY (FR FOG)
a. Remove the fog light relay from the engine room relay block.
Tester Connection
Switch Condition
Specified
Condition
A31-2 - Body
ground
Light control switch TAIL, front fog light switch
ON
11 to 14 V
Light control switch TAIL, front fog light switch
OFF
Below 1 V
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Lighting - Tundra
Fig. 35: Identifying Fog Light Relay Terminals (FR FOG)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
FOG LIGHT RELAY (FR FOG)
NG: REPLACE FOG LIGHT RELAY
OK: Go to next step
5. CHECK HARNESS AND CONNECTOR (FOG LIGHT RELAY - BATTERY)
a. Remove the fog light relay from the engine room relay block.
Fig. 36: Identifying Fog Light Relay Terminals (FR FOG)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Tester Connection
Condition
Specified Condition
3 - 5
When battery voltage is not applied to terminals land 2 10 kohms or higher
When battery voltage Is applied to terminals 1 and 2
Below 1 ohms
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Lighting - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст