Toyota Tundra. Manual — part 1741
Fig. 22: Locating Air Pump Insulators
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION
1
INSPECT AIR PUMP ASSEMBLY
a
Measure the resistance according to the value(s) in the table below
Standard Resistance
RESISTANCE REFERENCE
Tester Connection Condition Specified Condition
1 - 2
20°C (68°F)
0 4 to 1 0 ohms
1 - Body ground
Always
10 kohms or higher
2 - Body ground
2009 Toyota Tundra
2009 ENG NE Emission Control (3UR-FBE) - Tundra
Fig. 23: Inspecting Air Pump Assembly
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
If the result is not as specified, replace the air pump assembly
b
Check the operation of the air pump
1
Check that air does not flow from port A to port B
Fig. 24: Checking Operation Of Air Pump
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2
Apply battery voltage to the connector, and check the air pump operation
OK
2009 Toyota Tundra
2009 ENG NE Emission Control (3UR-FBE) - Tundra
VOLTAGE SPECIFICATION
Fig. 25: Checking Air Pump Operation
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
If the result is not as specified, replace the air pump assembly
INSTALLATION
1
INSTALL AIR PUMP ASSEMBLY
a
Connect the 6 air pump insulators to the air pump and install the air pump to the bracket
Fig. 26: Locating Air Pump Insulators
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Attach the 2 wire harness clamps to the bracket
Measurement Condition
Specified Condition
Battery positive (+) --> Terminal 2
Battery negative (-) --> Terminal 1
Air flows from port A to port B
NOTE:
Do not operate the air pump continuously for 2 minutes or
more.
When operating the air pump, wait 5 minutes until the
pump has cooled down between each operation. If the
pump has not cooled down sufficiently, the motor will burn
out.
2009 Toyota Tundra
2009 ENG NE Emission Control (3UR-FBE) - Tundra
2
CONNECT NO. 1 AIR INJECTION SYSTEM HOSE
a
Connect the 2 hoses to the air pump
HINT:
Insert the hoses until the hose ends are aligned with the stoppers
Fig. 27: Identifying No. 1 Air Injection System Hose
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3
INSTALL AIR PUMP INLET
a
Connect the air pump inlet to the 2 No 1 air injection system hoses
HINT:
Insert the inlet until the inlet stoppers are aligned with the hose ends
2009 Toyota Tundra
2009 ENG NE Emission Control (3UR-FBE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст