Toyota Tundra. Manual — part 2029
Fig. 285: Locating No. 1 Oil Pan Sub-Assembly Bolts And Nuts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Remove the oil pan by prying between the oil pan and cylinder block with a screwdriver
HINT:
Tape the screwdriver tip before use
Fig. 286: Locating Contact Surfaces Of Cylinder Block And Oil Pan
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
51
REMOVE NO. 1 OIL PAN BAFFLE PLATE
a
Remove the 7 bolts and baffle plate
NOTE:
Be careful not to damage the contact surfaces of the cylinder block
and oil pan.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
Fig. 287: Locating No. 1 Oil Pan Baffle Plate Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
52
REMOVE OIL STRAINER SUB-ASSEMBLY
a
Remove the 2 bolts, oil strainer and O-ring
Fig. 288: Locating Oil Strainer Sub-Assembly Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
53
REMOVE ENGINE REAR OIL SEAL RETAINER
a
Remove the 6 bolts and oil seal retainer
Fig. 289: Locating Engine Rear Oil Seal Retainer Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Using a screwdriver, pry out the oil seal retainer
HINT:
Tape the screwdriver tip before use
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
Fig. 290: Prying Out Oil Seal Retainer
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
54
REMOVE OIL DRAIN PIPE SUB-ASSEMBLY
a
Remove the bolt and oil drain pipe
Fig. 291: Locating Oil Drain Pipe With Mounting Bolt
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Remove the O-ring
55
REMOVE REAR CRANKSHAFT OIL SEAL
a
Place the oil seal retainer on wooden blocks
b
Using a screwdriver and hammer, tap out the oil seal
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
Fig. 292: Removing Rear Crankshaft Oil Seal
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
56
REMOVE RING PIN
57
REMOVE STUD BOLT
INSPECTION
1
INSPECT CYLINDER HEAD SET BOLT
a
Using a vernier caliper, measure the diameter of the elongated thread at the measuring point
Standard diameter: 10.85 to 11.00 mm (0.427 to 0.433 in.)
Minimum diameter: 10.6 mm (0.417 in.)
If the diameter is less than the minimum, replace the cylinder head bolt
NOTE:
It is not necessary to remove the ring pin unless it is being replaced.
NOTE:
If the stud bolt is deformed or its threads are damaged, replace it.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст