Toyota Tundra (2015 year). Manual — part 2876
NOTICE:
If the bellcrank lever is not pulled and held when installing the
handle, the bellcrank lever will interfere with the handle and
become damaged.
8. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH
(a) Install the front door inside locking cable.
(b) Attach the 3 claws.
9. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
(a) Install the front door lock remote control cable.
10. INSTALL FRONT DOOR LOCK ASSEMBLY LH (w/ Power Door Lock)
NOTICE:
When reusing a door lock that has been removed, replace the packing in the connecting part with new
packing.
Be careful that no grease or dirt sticks to the packing surface in the connecting part.
ENGINE HOOD / DOOR: FRONT DOOR (for Regular Cab): REASS...
screws.
Torque:
5.0 N·m {51 kgf·cm, 44in·lbf}
(d) Connect the door lock connector.
11. INSTALL FRONT DOOR LOCK ASSEMBLY LH (w/o Power Door Lock)
(a) Using a T30 ''TORX'' wrench, install the door lock with the 3
screws.
Torque:
5.0 N·m {51 kgf·cm, 44in·lbf}
12. INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH
(a) Using a T30 ''TORX'' socket, install the cover (with the door key
cylinder) with the screw.
Torque:
4.0 N·m {41 kgf·cm, 35in·lbf}
(b) Install the hole plug.
13. INSTALL FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY LH
(a) Install the frame with the 2 bolts.
ENGINE HOOD / DOOR: FRONT DOOR (for Regular Cab): REASS...
14. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH
(a) Install the frame with the 2 bolts.
15. INSTALL FRONT DOOR GLASS RUN LH
(a) Install the front door glass run.
16. INSTALL FRONT OUTER DOOR GLASS WEATHERSTRIP ASSEMBLY LH
17. INSTALL FRONT REAR DOOR GUIDE BRACKET GARNISH LH
18. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH
(a) Install the side airbag sensor with the bolt.
Torque:
9.0 N·m {92 kgf·cm, 80in·lbf}
19. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH (w/o Power Window)
ENGINE HOOD / DOOR: FRONT DOOR (for Regular Cab): REASS...
NOTICE:
(c) Insert the window regulator into the door panel. Use the temporary bolt to hang the window regulator on
the door panel.
(d) Temporarily install the window regulator with the 4 bolts, and tighten the temporary bolt so that it
contacts the door panel.
(e) Tighten the 5 bolts in the order shown in the illustration.
Torque:
8.0 N·m {82 kgf·cm, 71in·lbf}
20. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (w/ Power
Window)
(b) Using a T25 ''TORX'' driver, install the motor with the 3 screws.
Torque:
5.4 N·m {55 kgf·cm, 48in·lbf}
HINT:
21. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH (w/ Power Window)
NOTICE:
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст