Toyota Tundra (2015 year). Manual — part 2182
OK
OK
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
O11-1 (D) - Body ground
Always
10 kΩ or higher
O11-4 (U) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
4.
INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
(a) Remove the rear motor LH
.
(b) Apply battery voltage to connector terminals 1 and 2.
(c) Check that the motor gear rotates smoothly as follows.
OK:
MEASUREMENT CONDITION
SPECIFIED CONDITION
Battery positive (+) → 1
Battery negative (-) → 2
Motor gear rotates counterclockwise
Battery positive (+) → 2
Battery negative (-) → 1
Motor gear rotates clockwise
NG
REPLACE REAR POWER WINDOW REGULATOR
MOTOR ASSEMBLY LH
5.
CHECK HARNESS AND CONNECTOR (MASTER SWITCH - REAR SWITCH LH)
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
(a) Disconnect the N2 master switch connector.
(b) Disconnect the O11 switch connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
N2-12 (U) - O11-5 (SU)
Always
Below 1 Ω
N2-15 (D) - O11-2 (SD)
Always
Below 1 Ω
N2-12 (U) - Body ground
Always
10 kΩ or higher
N2-15 (D) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE POWER WINDOW REGULATOR MASTER
SWITCH ASSEMBLY
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
Last Modified: 9-16-2014
6.6 J
Doc ID: RM000000XI104GX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function): Rear
Power Window RH does not Operate with Rear Power Window Switch RH; 2015 MY Tundra [08/2014 - ]
Rear Power Window RH does not Operate with Rear Power Window Switch RH
DESCRIPTION
If the rear RH side manual UP/DOWN function does not operate, there may be a malfunction in the rear
switch RH, the rear motor RH, the master switch, or the harness or connector.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1.
CHECK HARNESS AND CONNECTOR (REAR SWITCH RH - BATTERY)
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
OK
(a) Disconnect the O5 switch connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION
SWITCH CONDITION
SPECIFIED CONDITION
O5-3 (B) - Body ground
Ignition switch ON
11 to 14 V
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
2.
INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH
(a) Remove the rear switch RH
.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст