Toyota Tundra (2015 year). Manual — part 2162
HINT:
Use the same procedures described for the LH side.
9. INSTALL ROOF HEADLINING ASSEMBLY
(a) for Regular Cab:
.
(b) for Double Cab:
.
10. INSTALL BACK DOOR GLASS CHANNEL (for Power Slide Type)
HINT:
Perform these procedures only when replacing the back window glass.
AREA
SPECIFIED CONDITION
a
10.0 mm (0.394 in.)
NOTICE:
Allow the primer to dry for 3 minutes or more.
Throw away any leftover primer.
Do not apply too much primer.
HINT:
If the primer is applied to an area that is not specified, apply non-residue solvent to a clean cloth and wipe
off the excess primer before it dries.
NOTICE:
Allow the primer to dry for 3 minutes or more.
Throw away any leftover primer.
Do not apply too much primer.
HINT:
If the primer is applied to an area that is not specified, apply
non-residue solvent to a clean cloth and wipe off the excess
primer before it dries.
(c) Apply adhesive to the back door glass channel.
WINDSHIELD / WINDOWGLASS: BACK WINDOW GLASS (for Re...
Adhesive:
Toyota Genuine Windshield Glass Adhesive or equivalent
After cutting off the tip, use all adhesive within the time written in the table below.
Usage Time Frame:
TEMPERATURE
USAGE TIME FRAME
35°C (95°F)
15 minutes
20°C (68°F)
1 hour 40 minutes
5°C (41°F)
8 hours
(2) Load a sealer gun with the cartridge.
(3) Apply adhesive to the back door glass channel as shown in the illustration.
(d) Install the back door glass as shown in the illustration.
(e) Apply non-residue solvent to a clean cloth and wipe off any
excess or protruding adhesive.
11. INSTALL BACK WINDOW GLASS WITH BACK DOOR GLASS CHANNEL (for Power Slide
Type)
HINT:
WINDSHIELD / WINDOWGLASS: BACK WINDOW GLASS (for Re...
Perform these procedures only when replacing the back window glass.
the glass channel fits between the ribs to install the back window glass.
(c) Using a T10 "TORX" driver, install the stopper with the screw (illustration A).
WINDSHIELD / WINDOWGLASS: BACK WINDOW GLASS (for Re...
12. INSTALL POWER WINDOW REGULATOR MOTOR
ASSEMBLY (for Power Slide Type)
(a) Using a T25 "TORX" socket, install the power window regulator
motor to the base plate with the 3 screws.
Torque:
5.4 N·m {55 kgf·cm, 48in·lbf}
13. INSTALL DOOR WINDOW REGULATOR BASE PLATE
(for Power Slide Type)
(a) Install the door window regulator base plate with the 3 nuts in
the order shown in the illustration.
Torque:
8.0 N·m {82 kgf·cm, 71in·lbf}
14. INSTALL DOOR WINDOW REGULATOR CABLE SUB-ASSEMBLY (for Power Slide Type)
(a) Rotate the drum assembly counterclockwise to align it with the motor pivot pin, and then connect the
motor drum assembly to the motor pivot pin.
NOTICE:
Do not rotate the drum assembly more than 45°.
WINDSHIELD / WINDOWGLASS: BACK WINDOW GLASS (for Re...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст